Your cart is empty.
Your cart is empty.Product Description
James Schubert
Reviewed in the United States on January 30, 2023
The lower part of the resin hardens in less than 45 minutes but there is a slimey layer that floats to the top which does not cure even if left for days. This is not the tacky layer that lets you apply additional coats to build thickness. If you add more than one coat, then sand, you sand into the slime between layers. It chips at the edge of the slime because the slime didn't harden and the slimey boundary between layers is a permanent and obvious flaw in your work. I had to sand all of it back off and used gelcoat from a different manufacturer, which worked a charm first time!
Charles R.
Reviewed in the United States on June 25, 2022
would order again
Ken F.
Reviewed in the United States on March 17, 2022
Use it all the time. Goid stuff
Junior and Regennia Pearce
Reviewed in the United States on August 21, 2021
Great product
Jim Teipen
Reviewed in the United States on August 21, 2020
I was looking for a way to spray gel coat a pair of rail mounted helm seats that I made for my sailboat. After researching it, I used this gel coat (no wax) mixed 1:1 with the Duratec High Gloss Additive and sprayed 2+ coats with a inexpensive HVLP spray gun with 1.8 mm tip. Worked great. There was a very small amount of orange peel which laid down nicely as the gel coat cures. Nice gloss as well.Prior to spraying, I was expecting to have to wet sand, compound and polish the cured gel coat, but in the end, the orange peel was so slight that I didn't bother. Saved a lot of time.
Tanner Boillot
Reviewed in the United States on July 4, 2020
good product
krzysztof P
Reviewed in the United States on June 12, 2019
Molds molds molds
Recommended Products