Your cart is empty.
Your cart is empty.Standard straight bit with a 1/2 shank for cutting grooves, dado's, mortising, and more.
Stan Samuelson
Reviewed in the United States on January 15, 2025
Worked just like it is designed
Jim
Reviewed in the United States on June 24, 2024
This is a well made bit that cut the exact groove width to fit plywood. Highly recommended.
JD Larrick
Reviewed in the United States on December 24, 2023
Best bits I have used. They cut cleanly and accurately, and stay sharp much longer than the cheapies. Worth the money.
Frank Wood
Reviewed in the United States on February 13, 2022
I used a cheap set of the plywood cutting bits and got very fuzzy edges and an undersized dado slot for cabinet grade "3/4" plywood. I bought the whiteside 23/32 bit and the cuts in the same plywood are super crisp and exactly the same size as the plywood. Mating parts fit tight but do fit in the dados cut with the whiteside bit. I will never buy the cheap bits again. Always go with quality tools if you want quality woodworking with clean crisp cuts.
John C.
Reviewed in the United States on July 15, 2021
Great but, did a lot of routing and it has great durability. For accuracy and clean cuts this router bit is great value for money
Thomas
Reviewed in the United States on January 25, 2018
Excellent bit for cutting dados for 3/4" maple and birch plywood. The bit cuts smoothly and uniformly, and I seldom have any issues with the veneer tearing or plywood blowing out. When I do have those rare issues, it's because of a blemish in the plywood stock and not the router bit. The bit also leaves the edge smooth with little if any need to hit it with fine sandpaper to remove any lifted grain. The joint is extremely tight (at least with the plywood stock I'm using) and makes for a solid and attractive joint.
David Justice
Reviewed in the United States on September 12, 2017
Awesome bit! Very sharp, cut about 200/ft of dados the day I got it and it performed great, no tear out at all. Also, these bit fit 3/4 ply perfectly! Makes making rabbets and dado's super easy.
JR from Austin
Reviewed in the United States on August 21, 2014
Purchased this because I didn't want to buy a dado stack for 3/4" plywood dadoes. It does the trick and seemed to match most box-store plywood for fitment. Smooth cut, and will look at their bits when I need a good one in the future. However, I bit the bullet on a dado stack two months later on a great deal, and for through dadoes there really isn't anything better. I still keep this bit around for stop dadoes in 3/4 stock, but I have yet to require that in my hobby work.
Recommended Products
$59.33
$ 31 .99 $31.99