Your cart is empty.
Your cart is empty.WWZMDiB 2 Pcs XH-W1209 12V Temperature Controller LED Display -50~110℃ With housing and 50 cm temperature probe 12V Thermostat
Panamon
Reviewed in the United States on June 4, 2024
My Creality Cr10s-Pro v1 used to run its hotend cooling fan continuously whenever the printer was powered. After installing Klipper, my desire was to leave the printer's power supply active, but I hated the constant/loud noise of the 24v hotend fan and have it on really bad authority that fan noise causes cancer!I used this module to interrupt the 24v to the fan and attached the thermistor behind the hotend heatsink. The module starts the fan once the hotend goes above 27°C, and stops it once it cools down.This Module did exactly what I hoped it would, and was easy to install and adjust.
Ken Doty
Reviewed in the United States on March 9, 2024
Well made.
Robb
Reviewed in the United States on December 16, 2024
When I am away, it’s nice to know that this thermostat will switch on a high powered window fan in my RV, so my pets do not overheat.
Mark S.
Reviewed in the United States on September 12, 2023
Some assembly required, but easy to do. All of the ones I have, would turn on (close the relay) at 2 Degrees over the setpoint, and It would turn off (open the relay) at the setpoint.I am measuring the temperature of my AC condenser. When the temperature of the coil is above the setpoint, a water mister system cools the system down.
Recommended Products
