Your cart is empty.
Your cart is empty.Product Description
36" Car Universal Throttle Cable Braided Stainless Steel Accelerator Black
Feature:
- 100% brand new and high quality perfect match for the original car.
- Useful replacement for your car, durable to use.
- Fit for most of cars.
- The length of outer stainless steel line and the connetor in the end part is 36"
Specification:
- Material: Metal
- Color: Black
- Size: 143x3x1.6cm / 56.30"x1.18"x0.63"(L*W*H)
- Note: Please allow 1-2 mm difference due to manual measurement.
Package Include:
- 1 x Throttle Cable
- 1 x Installation Tool
john silvia
Reviewed in the United States on July 5, 2023
easy to install
Ángel Rivera
Reviewed in the United States on February 11, 2023
I have a Mazda RX7 1982 and fit perfectly on my billet projay throttle body.
Álvaro Serna
Reviewed in the United States on April 3, 2023
Buena calidad. Fácil instalación
David P.
Reviewed in the United States on February 18, 2022
The covering is all frayed and the cable is wayyy thin compared to competitors.
steve mason
Reviewed in the United States on September 4, 2021
Kit is no different than the Lokar cable.
Customer
Reviewed in the United States on September 13, 2021
i like it being black to blind in with everything under the hood
Rod Burkhart
Reviewed in the United States on August 17, 2021
all in all nice part
The Givenator
Reviewed in the United States on May 30, 2021
Restoring an old Mopar truck, I decided to replace an old single-barrel carb with a new 4-bbl unit. Needed new everything: Exhaust headers, intake manifold, carb, etc. I found a simple throttle cable mount on Amazon for only $20, and shopped hard for a customizable throttle cable. This worked perfectly, but is tricky. (1) Mount entire cable in car for fit-check, the remove inner cable from outer housing. (2) Wrap housing area to be cut in tight masking tape, mark clearly, & only cut SS braid with Dremmel cut-off wheel. Cut teflon core with razor blade. Carefully, mount the cable in the adjustable throttle cable end-piece and mount to carb. Should be snug & stable. (3) Run cable thru pedal, inside housing to carb, and clearly mark for cut-length (making sure it can travel deeply into holder - test fitting prior to cutting is important.) Once you know the depth, cut cable with shape wire cutters. If the cable frays, you're in trouble. I found you want to gently tap-weld the wire tip to seal it together. (4) Done correctly, you get a factory result. Do NOT over-tighten the aluminum fittings.
Recommended Products