Your cart is empty.
Your cart is empty. Widely Used to process a variety of carving knives, (engraving rubber, bamboo, wood, stone) turning tools, pedicure knives and other cutting tools, can also be used for lathes, semi-automatic and automatic lathes, the outer circle, end face, inner hole, thread. Processing of planes, steps, grooves and cutting sequences.
Size: 8mm x 8mm x 200mm / 0.31" x 0.31" x 7.87"
Package Content : 3 x Lathe HSS Tool Bit
1923star
Reviewed in the United States on June 4, 2024
Fast delivery, good quality, just what you expect from Amazon Sellers.
Alex D
Reviewed in the United States on June 20, 2024
Absolutely the lowest cost I've ever seen for this product.
Customer
Reviewed in the United States on March 6, 2024
It is what I asked for. Use is for a wood lathe turning tool.
Customer
Reviewed in the United States on March 23, 2024
ok
richard
Reviewed in the United States on December 24, 2024
well suiter for my need.
PapaGoat
Reviewed in the United States on March 26, 2023
These work great for woodturning. Grind them and go! Holds the burr, nice steel.
W.P.
Reviewed in the United States on December 20, 2023
I had success using one of these on a sax reed. Turned the new/dry reed on it's back and lightly used the long edge flat on the reed to shave miniscule amount in order to flatten the back table. Reed sits flatter on the mouthpiece and creates and better seal. There may be other ways to improve reeds with this tool. Just getting started. The reed I worked on is improved for sure.
Zack B.
Reviewed in the United States on November 15, 2023
For the cost it’s great. Was able to cut in half and make 3 double ended tools.
Jerome Plourde
Reviewed in Canada on September 8, 2021
as described
David Phillips
Reviewed in Canada on December 6, 2020
It's worth paying a wee bit extra, not that these are expensive at all, but for this quality one would usually expect to pay more. I know I'll get many happy months of machining from these and will buy more when I have the funds, though I'll probably get 1/2" as I have to shim these little ones, roughly 1/2" is what I was hoping for, I got confused with the metric stuff. Purely my fault, Cheers!
Recommended Products
