Shopping Cart

Your cart is empty.

Your cart is empty.

XT60i to O Ring Terminal Cable,More Than 8A,10AWG Extension Cable XT60i Female to O Ring Connector XT60i-f Compatible with Lipo Batterie (1.5M/5FT)

Free shipping on orders over $29.99

$18.99

$ 7 .99 $7.99

In Stock

About this item

  • 10AWG cable 6mm2 with a XT60I adapter, some product detect the bridge and then break the 8 amp input current limit, so charging will be much faster.
  • materials ensure stable transmission under stable conditions. 10AWG (6mm2)power cables are very thick and durable.
  • Product length: 1.5M/5FT. XT60i female 10AWG cable. One end is the XT60i-f female connector. The other end is o-ring clamp cable.
  • Flexible length: the 1.5M/5FT length allows you to choose the right position to charge your device. More convenience and speed.
  • Widely compatible: XT60i-F to O ring clamp cable, connects power and battery, widely use for RC aircraft, RC toy cars, lithium batteries, xt60 port.



CHRIS BONNEY
Reviewed in the United States on March 5, 2025
Worked fine for connecting external battery to EcoFlo Delta 2. (You get about 200 watts transfer, so it slowly tops off the EcoFlow)
Oldduke07
Reviewed in the United States on February 20, 2025
Well made cable for DC charging aLIFEPO4 portable solar power station. One of those gotta have if you need it items.Works well!
J. Matin
Reviewed in Canada on February 13, 2025
The cable is performing like a cigarette lighter input port 8V cable not as the as the advertised XT60i 3-pin cable to charge with O-rings off a service battery. My cable also seems to be defective even in the way it was assembled (connector is askew). I cannot get more than 102 watts to charge my Ecoflow Delta 2 generator therefore the same as the cigarette lighter cable. I will be returning.
Thunder God
Reviewed in the United States on January 30, 2025
This item seems well made. The terminals seem secure. Have not used them to charge my power station yet.
Tam
Reviewed in Canada on January 30, 2025
I could only pull 100 w of my 12.8 volt lifepo4 battery to my ecoflow power station.
BT
Reviewed in the United States on January 24, 2025
Cables are thick 10ga but still soft and malleable. Worked perfectly for what I needed.
martineau, Eric
Reviewed in Canada on January 24, 2025
Excellent produit, beaucoup plus efficace que des pinces. Supporte le 15 amp sans chauffe, souple et suffisamment long. J’utilise des batteries acide-plomb en 24 volts pour les jumelé à une Delta 3 plus. Cela me donne une plus grande autonomie pour ma maison. En 24 volts, la Delta 3 plus tire 345 watts des batteries externes (4 batteries x 6 volts). En 12 volts c’est 175 watts. Donc la Delta va prendre le max qu’elle peut soit 15 amp.
James Dean
Reviewed in the United States on January 21, 2025
Well Made cable XT60I makes charging my Echoflow easier from external batteries
VINCENT
Reviewed in the United States on January 16, 2025
Works as advertised, good quality cables so it seems so far
Caveman
Reviewed in the United States on December 29, 2024
I use this to charge my power station with lifepo4 batteries. It just about doubles the charging speed. Of a standard xp60 cord.
JayBear
Reviewed in the United States on December 28, 2024
12awg wire insulated at 60C (which this product is) is rated for up to 20A of current. The Delta models from Ecoflow are limited to 15A of current on their XT60 port when using XT60i, so this is a perfect fit! Here you can see it connected to an AOLithium 100ah 12v LiFePO4 Battery which is plugged into our Delta 3.Works great and feels great. The leads leading up to the battery are barely wide enough to reach the terminals, so be careful if you have to split them at the insulation to make them reach. Luckily, I did not have to.
Recommended Products