Your cart is empty.
Your cart is empty. 1.M1 chip
2.anti-metal
3.25mm diameter.
4.with adhesive back.
NIGHTCOM
Reviewed in France on August 25, 2024
pourrave ne peux pas remplacer une carte assabliy. pas reconnus par lap pareil. a éviter
Ahmad
Reviewed in Canada on May 18, 2022
You cannot write over them, only reading works. They are useless
JakeF
Reviewed in the United States on May 24, 2021
Only two of the tags I received worked with my RFID reader. I had 3 other packs of tags from different sellers and all of them worked from each of the other packs, so it wasn't my reader.
Espongo Pulazzo
Reviewed in the United States on January 30, 2021
Completely unacceptable failure rate. I might be OK with 1 out of 8 not working, but 50% is garbage.
Billy & Nicole
Reviewed in the United States on July 3, 2020
Does not work on my 13.56 MHz cabinet locks
Customer
Reviewed in the United States on May 14, 2020
I have tried several mifare ultralight c and classic 1k stickers with these by far being the best of the ones i tried. they are 100% compatible with salto encoders as well as both the online and offline salto locks.
Mr. Revilla
Reviewed in the United States on January 13, 2020
I’ve using this tags to place near my entry door at home and at work to control certain automations / webhook triggers. The quality and the fact that they work on metal is there....I did however had two that would not write. Almost seemed locked up. Other than that they work on metal and they look water resistant so that’s definitely a plus.
Mr.A
Reviewed in the United States on April 25, 2020
Works with my smart door lock
Jacob H.
Reviewed in the United States on September 16, 2019
Block 0 is not writable on these. They read fine, but if you need to be able to write to Block 0 you are out of luck.
Rz8898
Reviewed in the United States on April 8, 2018
Works perfectly, MIFARE Classic with Saflok key encoders and locks.
Recommended Products
