Your cart is empty.
Your cart is empty.For Subaru BRZ Toyota 86 2013-2020. Before placing order, please confirm this product is suitable for your car?thank you !! Condition:100% Brand new. Material:Made Of High Quality ABS plastic. Made in an ISO 9001 facility to ensure highest quality.Easy Installation,3M automotive adhesive tape is attached. Install Instruction: 1.Clean the place where you need to paste and then wipe the water with towel or tissues. It can't accept to have the oil ,water, wax ect. 2.Determine the installation location and then make comparison of the product and installation location, if the product doesn't fit to your vehicle,please contact us immediately and don't install. 3.When tear off the double-sided adhesive of cover trim, you can't touch the double sided paste with hand. 4. In order to achieve better effect, we suggest to heating double sided adhesive by hair dryer or lighting. 5. Alignment position and then paste, the paste depends on paste conditions and correct way to install. 6. Please pressing 20-30 seconds or more when paste and don't dip the item into the water within 48 hours.
Crystal
Reviewed in the United States on March 17, 2025
Looks amazing
bryson28713
Reviewed in the United States on February 6, 2025
I compared this carbon “look” to a real carbon bezel. I found this one looked better inside the car. Real carbon looks great in the sun, sun light doesn’t really touch this part of the interior. This bezel was more vibrant and just looked better. Covers up the poor quality silver the factory did.
Tomas Rodriguez-Andrade
Reviewed in the United States on February 16, 2025
Very easy to install. Sticks on very well and fit my FRS well.
James Butler
Reviewed in the United States on July 19, 2023
So unfortunately, as soon as I opened up the box that this was in, some of the adhesive was already coming off and other sections when removing the strip so I could apply it to the vehicle. It pulled the entire adhesive section off. Also, if you can tell from the photo it's not a tight fit around the shifter so I can see a little bit of the underlying material which was disappointing. Besides those two issues, I definitely like the look it gives
Ya boy Doofy
Reviewed in the United States on August 17, 2022
Cheap plastic underneath but that might be due to it needing to be thin for application since this is a cover piece not a replacement plastic piece. It sits almost perfectly flush which is nice. The plastic glue sticky pads seem cheap but again might be due to needing it sit flush. For now it seems really nice for what it is and the outside finish is very nice and smooth. Will update if the puss me off down the road
Jessica Armstrong
Reviewed in the United States on July 5, 2022
Fit perfectly, there is a bunch of tape strips on the back, if you have long nails I recommend getting a pair of tweezers to save time peeling off the backing on the tape. Wiped area off with a alcohol wipe, dried, put it on, and held it in place for a moment. Has stayed on well and looks good
Truebeef
Reviewed in the United States on April 10, 2022
Looks good and fits well easy to install
Chris R.
Reviewed in the United States on September 13, 2021
I was worried this was going to be a cheap junky sticker and it ended up being a really high-quality overlay. Fitment is great and feels very quality and near OEM. Would definitely recommend it. Spruced up my scratched up shifter trim.
Recommended Products
