Shopping Cart

Your cart is empty.

Your cart is empty.

YUCHENGTECH Automatic Edge Bander Banding Machine Woodworking Edge Bander Banding Machine Wood Sealing Trimming Edge Bander Double Sided Gluing Automatic Feed/Break Belt Straight edge banding 110V

Free shipping on orders over $29.99

$2.90

$ 0 .99 $0.99

In Stock
  • 1.【Upgrade fully automatic】: Full automatic feeding, multiple plates can be banded and trimmed at once. Main functions: automatic feeding, double-sided gluing, automatic breaking, automatic trimming, automatic polishing, intelligent temperature control.
  • 2.【Customized 110V】: Upgrade the stable motor to ensure stable operation of the edge banding machine and trimming machine, the product is of good quality and can meet most people's edge banding needs,
  • 3.【Profiling trimming function】: Edge trimming can be carried out on both sides at the same time, edge banding and trimming can be completed at one time, greatly improving the work efficiency.
  • 4.【Applications】: This product is mainly used for straight edge banding, with higher working efficiency, many buyers who generally purchase this product are commercial buyers of mass production. Suitable for all kinds of plates and edge strips, such as: ABS, PVC, particle board, melamine board, fine wood board, MDF, integrated board, acrylic board, etc.
  • 5.【Matters need your attention】: Adjust the heating temperature of the temperature control table (the temperature depends on the melting temperature of the hot melt adhesive, and the machine uses 120-180 °C medium and low temperature hot melt adhesive). When the heating reaches the set temperature, the motor switch light will illuminate and press the switch motor to start. It is recommended that the machine be preheated for 10 minutes before the edge is sealed before starting the motor to allow the hot melt to melt completely.



Product Description

 Automatic Edge Bander Banding Machine
 Automatic Edge Bander Banding Machine
  • 1.Incomplete melting of hot melt glue. ---Open the melting pot cover to check the hot melt glue.

    2.Insufficient glue. --Adjust gluing knob.

    3.The bending stripdeformated. --Replace a better edge banding tape.

  • 1.Non parallel adhesive veneer. --Re-calibratethe support plate(see manual)

    2.Heating for a long time, hot melt glue is deteriorated. --Change hot melt glue

    3.Hot melt glue temperature is not the correct temperature. --Adjust the temperature.

  • Twist strake attached starting point/push slower than the speed.

    --The support plate should be flush with the workpiece when pressing and fit the starting point, the edge to the workpiece, can not loose.

  • Hot melt glue not yet dissolved

    ---Need to re-adjust the temperature, and then start running.

  • Wheel or feed wheel skid

    --Clean the belt pulley and the feed wheel.


George Nash
Reviewed in the United States on November 28, 2024
A bit sporty engaging the tape but otherwise does the job
Rex
Reviewed in the United States on October 29, 2024
Machine required a little tweaking to accommodate my shops needs . It operates as advertised does a great job for the costs . I run mainly 1 mm wood edge banding