Your cart is empty.
Your cart is empty.YUNGUI 5PCS Perf Board Stripboard,9X15cm Copper Circuit Board Single Sided PCB Board Breadboard For DIY Arduino Soldering and Electronic Experiment
Features:
Includes 5pcs 9x15cm blank 5 Joint Hole PCB board.
You can cut these pc boards into any shape any size for your needs.
Electronic parts and Electronic equipment replaced and Repaired include: LCD Modules, Optoelectronic Displays, Capacitors , Resistors , Potentiometers , LED Displays , Electronic Accessories & Supplies,Electronics Stocks,Ative Compent , Integrated circuit , Diode , Transistor.
Product Description:
Quantity: 5pcs
Dimension: 90x150x1.2mm/3.54”x5.9”x0.05”
Specifications: single-sided
Hole Pitch:2.54mm
Hole diameter:Approx. 1mm
Thickness: about 1.2mm
Material: Great quality of Epoxy glass fiber FR4
Color: yellow basic, Red copper tone
Package List
5pcs 9*15CM 5 Joint Hole PCB prototype circuit board
Brian Tamburelli
Reviewed in the United States on November 19, 2024
I like how these are patterned out like a breadboard! Great addition to my Electronics Laboratory Bench!
Ancel Long
Reviewed in the United States on October 14, 2024
Works as expected
Ben
Reviewed in the United States on March 5, 2022
Would like to have boards available with power supply routing tracks already etched around the perimeter or half way around the perimeter of the board
L. Masn
Reviewed in the United States on March 14, 2022
The board is thin but sturdy, however the copper leads are very delicate. Too much heat and they burn right off. A small tug from a wire can easily peel them off. Also it's not easy to fill in the holes with solder. On the positive side, it's very easy to make an intentional break in the circuit by cutting or scraping a lead with a hobby knife, and it's very easy to use a Dremel to cut the board down to a smaller size.I don't think I'd buy them again, but they're fine for small projects and temporary mockups. Comes in a pack of 5, 15 x 9cm, 1.2mm thick, 48 columns by 30 rows. (I purchased these to build the 1980s Usborne Robot because the dimensions are similar to Veroboard and close enough to the book's schematic with slight alterations.)
Tom
Reviewed in the United States on November 30, 2021
Very convenient for creating low voltage power distribution boards for LED strips. Can be populated with flexible length screw terminals.
john
Reviewed in the United States on April 28, 2021
These boards are quite nice. Beginners may have a tough time with it, but if you can solder cleanly and precisely, they are much better than some of the other lower quality strip boards I've purchased. Good for the money for sure.
C318cuin
Reviewed in the United States on February 24, 2020
Easy to use. Great value. Stands up well to heat. Pads are well attached.
S. A. ROBBINS
Reviewed in the United States on November 15, 2020
I like the quality and I like the design of these prototyping boards. Handy for a lot of electronics projects.
Recommended Products
