Your cart is empty.
Your cart is empty. Features:
1. Supports direct serial port control, position and status reading, and system parameter setting.
2. Supports setting system parameters through screen buttons, with automatic saving, which can completely eliminate the need for a host computer.
3. Power-on self-test, automatic identification of certain parameters, automatic judgment of some errors, and prompts.
4. Supports 42 stepper motors of any length with 0.9 and 1.8 degrees.
5. The closed-loop motor feeds back the rotation angle of the stepper motor to the driving circuit to check if every intended step has been taken, aiming to prevent step loss.
6. In case of step loss, the closed-loop system will compensate based on the feedback received. Upon step loss, the blue LED light on the closed-loop module will light up (the blue LED light serves as an indicator for step loss).
7.Position/speed/torque- closed-loop, it can run at high speed without losing steps-.
8.Field-Oriented control, low noise, low and low calorific.
9.4 Half bridge driver with 8 MOSFET, high operating efficiency.
10.Support 1-256 subdivision，odd subdivision is also avaible.(Such as 11 subdivision)
11.speed 1000RPM.Support motors- with 0.9 degree or 1.8 degree .
12.The printing speed can reach 150-180mm/-s and easy to install and wire.
Specifications:
Board Type: SERVO42C -V1.0
Microprocessor: Crotex-M0+
Mootor Driver: 4 Half bridge driver with 8 MOSFET
Input : 7V-28V
Encoder-: 14 Bit Magnetic Encoder-
Adjustable Current Range: 0-3000mA
Subdivision：1-256（Default 16）
Speed: 1000RPM
Resolution: 0.08degree
The Frequency of Update: Position 10Khz / Velocity- 10Khz/ Torque-20Khz
Package:Without Motor
$40.00
$ 18 .99 $18.99