Shopping Cart

Your cart is empty.

Your cart is empty.

1 Inch x 39 Inch SDS Plus Rotary Hammer Drill Bit – U-Flute - Masonry Drill Bits with Carbide Tipped for Brick, Stone, Concrete (1'' x 39'')

Free shipping on orders over $29.99

$35.99

$ 18 .99 $18.99

In Stock

About this item

  • High-Quality Bits: Cemented carbide YG8C provides outstanding hardness and durability, making the bits perfect for chipping off bricks, concrete, stones, and other masonry construction materials.
  • Greater Precision: The YG8C carbide centring tip for easier penetration of the material and drilling a precise hole.
  • U-Shaped Flute Design: Each drill bit features a U-shaped flute to achieve quick dirt removal and keep the drill bit running smoothly and cooler.
  • Wide Adaption: This sdrill bit is perfect for working on masonry applications, brick, stone, concrete, block, stucco, etc.
  • Universal Shank: The SDS PLUS shank is suitable for most rotary hammer drills and meets most of your needs. Such as Bosch, Hilti, Milwaukee, Makita, Dewalt drills and other SDS/SDS Plus Hammer drills etc.



Victor Blake
Reviewed in the United States on March 20, 2025
Meh. Not impressed. The tip is not sharp enough to drill into rock without bouncing about quite a bit. Keeps hopping off the rock. Probably fine for CMB, but not recommended for rock. I prefer the Hilti even granted how much more it costs.
MoonDoggy
Reviewed in the United States on November 5, 2024
This is a very long bit and would recommend pre-drilling with a shorter bit first. Any vibration will cause the bit to wobble. In my case, I used a Bosch 4 point 18in drill bit to pre-drill the pilot hole through the concrete. Once the pilot hole is drilled and clear, then I used the long bit as-much-as possible. This 39in bit is narrower flute than that the Bosch bit. Maybe this is a good thing due to the stress on the battery drill hammer getting down that far into a hole. Once I got past the concrete and bed rock into the soil, the motor handled it ok. If there was more rock, then maybe upsizing to a SDS-Max system would be required.In my case, I got lucky and the bottom soil was clay with some rock. This allowed me to get the 8ft ground rods down half way before breaking out the 10lb hammer. Yes, I know about the SDS-Max ground rod bit but I am not going to pay that kind of money for just 2 holes.The only other con was in relation to the flute filling up with the clay soil. Since it is smaller, it filled up pretty quickly.Bottom line, I got the job done as I had hoped for.