Your cart is empty.
Your cart is empty. Description:
1. Total 10pcs with professional design. The output can control high-power equipment, motor, bulb, LED strip, DC motor, micro pump, solenoid valve, etc. It can input PWM, control motor speed, lamp brightness, etc.
2. We can use dual MOS parallel active output, lower internal resistance, larger current and strong power.
3. Operating Voltage: DC DC 5V--36V; continuous current 15A at normal temperature; power: 400W; The maximum current can reach 30A under auxiliary cooling conditions.
4. Supports the PWM signal, the signal frequency is 0--20KHZ, which can control motor speed, lamp brightness and so on.
5. Wide voltage, support PWM;Easily control high-power devices;Service life: unlimited switch; working temperature: -40-85 ¡ã C; size: 1.34x0.7x0.5 inch/3.4 x 1.7 x1.2cm(L*W*H)
Chris S.
Reviewed in the United States on September 21, 2022
Having + and - input terminals as well as a similar pair of out put terminals plus a pair of control terminals, would imply that there is no connection between the control terminal and the power terminals just like a double pole relay. However since there is no optical isolation on the board I can see, this is not true. The FET is really just a switch to ground of the control terminal and you have to figure out just what the circuit is and wire accordingly, making sure the correct power terminals are also common with the Gen. Terminal or you’ll blow the whole thing up. It’s reall just a three terminal device with a bunch of extra connectors!
P. Meyer
Reviewed in the United States on October 16, 2022
It wasn’t clear to me so I tested it, the device does switch 12v with a 5v signal.I only tested one so I don’t know how many of them actually work.
Recommended Products
