Your cart is empty.
Your cart is empty.Jon C. Kimbrell
Reviewed in the United States on March 2, 2025
It grabs maybe 3 threads before binding up. Do not buy for a DeWalt router
Pat Traynor
Reviewed in the United States on August 6, 2024
...but at some point I will! And when I do, I'm going to need it right now. These collets are a perfect fit for my BOSCH 1617EVS router. If it goes down, I'm dead in the water until I can get a replacement sent to me. For short money, this gives me peace of mind.
Tony Stabler
Reviewed in the United States on August 22, 2024
Perfect replacement for lost collet. Retailers don't carry replacements & specs are hard to find. Mastercraft uses same collets a Dewalt full size routers. Delivery time was fine.
Customer Review
Reviewed in the United States on August 11, 2024
I obtained these to add to my router kit for 1/4" shank bits. These appear to be comparable to the OEM collet and nut, with a few minor differences. These won't fit the OEM 19mm/22mm wrench since the nut is slightly wider. A 24mm wrench will be needed for these. The thread engagement is about half of the OEM, at about 2.5 rotations to finger tight and another 1/2 rotation to fully tighten, whereas the OEM nut is about 5.5 rotations and 1/2 rotation, respectively. The collet sticks out about 2mm further than the nut, instead of being flush like the OEM collet and nut. In testing this collet, I saw no wobble issues and it performed fine.Overall, I am satisfied that this will do a good job and last a long time.
jason
Reviewed in the United States on October 16, 2024
No issues whatsoever
Recommended Products