Your cart is empty.
Your cart is empty.Connects 2 pocket door frame headers to make a continuous header for converging pocket door openings. Fits 1500 series pocket door frames. 2 pieces of steel sandwich headers between them for added strength. Connects 2 pocket door frame headers to make a continuous header for converging pocket door openings Fits 1500 series pocket door frames 2 pieces of steel sandwich headers between them for added strength Yellow zinc plated steel.
M. Farrell
Reviewed in the United States on May 28, 2023
Used for the intended purpose, it worked well, channel and plate were thick steel, lag screw was appropriately long. I could probably fabled up something similar, but if you are charging for time, this was an efficient solution to lining and supporting up two door tracks.
MplsBuyer
Reviewed in the United States on March 20, 2023
This kit works well to join two tracks to allow two pocket door frames to be used for converging pocket doors. Instructions are straight forward.They provide a 1/4" lag screw to hold the middle where the tracks connect to the header (or wood) above the tracks. It is a good idea, but is a bit flimsy.No worries, easily fixed by replacing a few of the screws that hold the metal part of the track to the wood just above the track, with a longer screw that goes through that track into the header above the frame. Something like a 3" drywall screw or equivalent should be fine. Maybe 2 of these screws per track and a shim above it makes the track much more solid.WHile I'm thinking of it, you might also consider, adjusting the kit to allow room to screw wood stock where the split trim on each side of the door would go. Maybe mount the metal studs 3/4" farther back from the door opening, allowing space to screw a 3/4" x 5/8" piece of construction wood to the steel stud. And then you can use finish nails (nailer) to attach the finish trim to the wood you just screwed on. No screws visible this way. Overall a good frame kit. Would buy it again.
john d. suchnick
Reviewed in the United States on February 9, 2021
Did exactly what it.was meant to do.
Craft
Reviewed in the United States on January 25, 2021
Ive bought a few of these now. Unfortunately, if you need just the stops, this package is the best deal, and the other parts get tossed out. Great stops.
J. R.
Reviewed in the United States on January 9, 2019
Needed this kit mainly for the stops. Just what I needed for my converging pocket doors. Could not find these items locally.
pigomatic
Reviewed in the United States on January 21, 2019
You could install converging pocket doors without this, but the kit will save a lot of time. To give the center bolt more holding power, install a one inch diameter dowel, staying an inch above the bottom of the header.
Fred
Reviewed in the United States on December 29, 2012
I installed 2 single pocket doors and 1 double in my basement. I had never installed any pocket doors before so I was anxious about getting the doors in and getting smooth movement. Also, I used solid core doors so I was afraid of the weight bearing strength of the installation. This connector worked great and with some adjustments on the slider on each door I got an even tight close on the double pocket door. If you can install pocket doors, installing a double is only slightly more difficult
Jay C
Reviewed in the United States on November 25, 2009
Worked ok in my situation - directions were not that clear (which matches the unclear Johnson pocket door install instructions). Pictures are good but never the final answer. Need more verbage on how to properly install in different situations.
Recommended Products
$34.95
$ 17 .99 $17.99
$17.99
$ 7 .99 $7.99