Your cart is empty.
Your cart is empty. #2 (DFE102B) BLACK Square Base EPDM Flexible Pipe Flashing
-Continuous Service Temperature Ranges of -58F to 239F (EPDM)
-Flashing Base is 7" x 7" - Pipe Boot Fits 1/4" to 3" Outside Pipe Diameter
-Easily Customize Pipe Boot Size on the Job Site With Shears or Heavy Scissors
-EPDM Rubber Boot with Flexible Base (Aluminum Collar) Seals Against Uneven Metal Roofing
-Slide Flashing Down Pipe and Fasten Aluminum Collar To Roof With Metal Roofing Screws Every 1-1/2"
-If Trimmed and Installed Correctly, Pipe Flashing Will Not Break or Crack
-Reduces Building Maintenance Due To The Long Life of the Dektite Product
-Use for Stove Pipes, Chimneys, Plumbing, Heating, Air Conditioning, Electrical, and Exhaust Vents
-20 Year Manufacturer's Warranty Against Manufacturing Defects
Works with Metal Roof Pitches up to 12/12 (0 to 45 degrees)
On a Roof with a 10/12 to 12/12 Pitch (45 Degrees) Dektite Recommends You Use a Square Base Pipe Flashing Installed With The Base Tip Pointed Towards Roof Top. When Used With Deep Ribbed Profile Roofing Panels With 1-1/2" Deep Corrugation Or More, Consider Using Next Size Up That Will Accommodate The Same Diameter Pipe
CAUTION This product is not rated for temperatures experienced by prolonged contact with a single wall chimney. Manufacturers Recommended Temperature Ranges Are Clearly Stated Please Verify This Product Will Meet Specifications Of Your Installation Or Product Damage May Occur
For single wall chimney applications consider using a High Temperature Silicone Flashing product that is rated for high temperature applications
BrusselsSprout
Reviewed in the United States on September 22, 2024
We were able to cut an accurate circle for our 2" conduit using strong, stubby scissors. We recommend perfecting your cutting technique on a smaller hole than you need. It will make your final cut much better and easier to execute.The trim plate was easy to conform to the ridges on our metal wall. Note that on a vertical surface the trim piece should be on a diagonal in order to shed water instead of trapping it on a horizontal top edge.
Darla Mills
Reviewed in the United States on September 15, 2022
Great quality
Parts D.
Reviewed in the United States on June 28, 2021
great design, easy to use, and fits a lot of applicatons
Richard H Langlois PhD
Reviewed in the United States on October 3, 2021
Excellent
Tajh L.
Reviewed in the United States on February 9, 2020
Used it for a stove jack on my tent and it works great.
Recommended Products
$17.99
$ 7 .99 $7.99