Your cart is empty.
Your cart is empty.Product Description
Note
It is easy to install, but professional installation is highly recommended!
Erica
Reviewed in the United States on February 1, 2025
Product was exactly as described, I had no issues putting it on my honda rebel 250.
Jessica L.
Reviewed in the United States on November 16, 2024
These are crap don't buy them for rebel 250
Customer
Reviewed in Canada on April 30, 2024
they work
hb
Reviewed in the United States on September 1, 2023
There is way too much rubber around the carburetor side of the boot, really had to shave the excess rubber down with a knife just so I could get the piece flush. And the other intake boot was cracked already as you can see in the picture. Not great quality, but I didn't pay much money for them.
Kevin Johnson
Reviewed in the United States on June 3, 2023
I don't know if I recieved a defective part, but it feel apart on the first ride. I ordered a 2nd set and if it is also defective I will leave another 1 star rating.
jason
Reviewed in the United States on May 24, 2023
It doest fit at all. Original intake manifold assembly has a short and long stud. It would of been nice if hardware came with to accommodate for this and clamps to connect ti the carborater.
Casey L.
Reviewed in the United States on September 24, 2022
The media could not be loaded.
Jake L.
Reviewed in the United States on August 22, 2021
Used these to convert a 2005 honda rebel single carb to a dual carb. No instructions and no clamps with them. Had to trim the rubber off the outside to make them fit.
Andre
Reviewed in the United States on August 17, 2019
They are working great on my Roketa 250 chopper. They are metal with a rubber outer layer, and they included the o-rings.
Recommended Products