Your cart is empty.
Your cart is empty.ACDelco Professional Engine Coolant Temperature Sender is an ideal high quality aftermarket replacement component for one or more of the following vehicle systems: ignition, and/or engine fuel management. This premium aftermarket sender is manufactured to meet or exceed your expectations for fit, form, and function.
John Paradiso
Reviewed in the United States on August 17, 2024
factory parts are the best to use
Shawn H
Reviewed in Canada on July 3, 2024
The product did not work. Most likely a knockoff/fake that was useless out of the box.
Dustin Rowles
Reviewed in the United States on June 19, 2024
Good product. Comes ready to installWorks well
James
Reviewed in the United States on March 15, 2024
Works well and reads accurately
Kathleen M Lenz
Reviewed in the United States on February 27, 2024
1987 K5 Blazer with 350 TBI.Perfect fitFixed the issue of the temp gauge not working. Easy to install
Mario Brideau
Reviewed in Canada on April 7, 2024
Bonne qualité
Bill
Reviewed in the United States on August 30, 2022
Genuine part at way less money.
T.Chags
Reviewed in the United States on September 10, 2021
Bought it for my 84 k20, works nice with gauge, but it reads hot, at 220, t-stat is a 195, someone else bought it for a similar truck and said it ran 60° plus above normal temp. Not sure why but I believe the same is happening to mine. It doesn’t spike up or down, but stays steady in between 210° and 220°, will return because for $30 I’d expect a better read.
Tom
Reviewed in the United States on October 13, 2017
Made my temperature gauge on my 81 Vette run true. Run a little hotter put actually goes up and down slightly as I drive, not spike up, spike down, repeat.
joe h
Reviewed in the United States on July 14, 2016
My temp gauge quit working so I went to the local auto parts store and bought a replacement, which read about 30 degrees above normal. Returned that and got this one and reads right on the mark.Read somewhere that the one wire sending units use the engine block for ground (return) and not to use teflon tape. Used high temp thread sealer and not a leak. Happy with this purchase.
Recommended Products
