Your cart is empty.
Your cart is empty.Product Description
Jimandy26
Reviewed in the United States on February 3, 2025
The media could not be loaded.
gian parisi
Reviewed in the United States on January 14, 2025
They are great , good finish and material, and fit great to my bike Morini X cape 649
Ryan Skills
Reviewed in the United States on September 27, 2024
I suppose if you get these for a kid that is light weight you’ll be fine. If you are over 100 lbs maybe get steel pegs. These are not billet aluminum or forged. They are low quality trash pot metal probably just melted Coke cans lol. Look nice and painted well but just don’t expect them to hold up to jumps.
Evan D
Reviewed in the United States on September 11, 2024
These foot pegs are 10x better than the stock mini bike foot pegs
Andrew Horan
Reviewed in the United States on August 22, 2024
These fit the bt200x and probably other Coleman mini bikes. I did have to drill the pinhole out a tiny bit but not much. And overall, I think the quality of this one over the factory cast aluminum is bar none. Installation was very easy. Remove the old one. Drill the hole a little bit bigger. Put this one in. I however did not use the spring because I don't like them and I would prefer if they just flopped when I needed them to flop. The overall performance of this small part is so much better than the original, your feet don't slip as much. There's a much larger pad for you to put your feet on and you can really stand up when you need to and not worry about it. Breaking as it is steel and it's powder coated and they look amazing. 10 out of 10 would buy again.
Customer
Reviewed in the United States on May 13, 2024
Springs and pins were nice, the pins were too short for an EGL 250, but reused old pins. 5 minutes of hard riding broke the peg with just my body weight, 220 lbs.
Family account
Reviewed in the United States on November 29, 2024
Highly recommend if you’re looking for an inexpensive upgrade to your minibike footpegs. So far they’ve outlasted the last 2 pairs of oem replacement pegs I’ve purchased. Only modification needed is to drill out the factory mounting holes and I recommend to use bolts with a lock nut as the springs aren’t necessarily intended to be used with the minibike chassis and may or may not fit which will leave your peg extra floppy. for at the time of purchase $12 dollars and a very easy modification I will be using these for all of my future minibikes and friends bikes
John Carmano
Reviewed in the United States on October 9, 2024
Huge huge upgrade from the stock footpegs. These are basically double the width and protrude out much better for rider of any age. Super easy to install. The spring part of it was a bit confusing to figure out as I didn't find any instructions with them, but essentially one end of the spring hangs against the top of the pedal and the other end compresses and hangs over the top of the connection where the pedal meets the bike. It came with new pins and cotter pins (think thats what they are called), which was awesome.
Recommended Products