Your cart is empty.
Your cart is empty.Description: Intake runner bosses cast in for nitrous or fuel injector ports Port exit dimensions: 1.078 in. W x 2.155 in. H Estimated runner length - Shortest: 5.00 in. Estimated runner length - Longest: 6.250 in. No provision for divorced or heated choke ; Specifications: Basic Operating RPM Range:1,500-6,500 Gasket Or Seal Included: No Application: Application Specific Center Maximum Height: 5.350 in CNC Ported: No Manifold height: Front (A) 4.875 in., Rear (B) 5.750 in. (A + B divided by 2 = 5.3125 in. pad height) ; Material: Aluminum Single Or Dual Plane Type: Dual Plane ; Packing included: 1 x intake manifold some fittings
Joseph
Reviewed in the United States on February 20, 2024
Quality product, fits well.
Michael Anthony Davis
Reviewed in the United States on January 27, 2024
This does not fit the LA small block mopar motors. This only fits pre 1979 small blocks. Says it fit for my 1983 D350 but it most certainly does not. Return window is way too short and not I am stuck with basically a boat anchor
Shawn Shaw
Reviewed in the United States on March 7, 2023
I went to install it on my 1981 Dodge D150 with the 318 and the bolt holes didn’t seem to line up properly, build quality is nice. I’m sure for the price and if someone’s good with machining they could make it work or unless my blocks heads are different
Larry Lawther
Reviewed in the United States on October 16, 2023
purchased this manifold hoping for the best, guess not. nothing but vacuum leaks and coolant leaks into the lifter valve and into the oil pan. tried 2 different sets of intake gaskets and I couldn't get the intake to seal .
Jonathan
Reviewed in the United States on September 4, 2022
Good price for a knock off air gap.
Jade alford
Reviewed in the United States on September 2, 2022
So very thankful for the customer service of this company they worked with me to get the intake shipped as soon as possible with expedited shipping so I could get my car running and to a charity event for the loss of a family member I am extremely greatful and along with the great customer service the intake is such a high quality and in comparison to the major brands the quality matches or exceeds the major brands as well for half the cost I will use this seller for as many parts as i can from now on again i appreciate your team for amazing customer service and a even better product
HHayes
Reviewed in the United States on August 1, 2022
Went to install this intake on a 1978 LA360 and it is 1/2 inch to wide. There is no way this intake will bolt on the advertised engine. So now I have a truck sitting pulled apart until I can get a new intake manifold elsewhere.
Recommended Products
