Your cart is empty.
Your cart is empty.Todd M. Caldwell
Reviewed in the United States on January 8, 2025
I bought these to use as bushings so I could use wheels with 1/2 ID bearings on a cart with 3/8in axles. The 3/8 part fit just fine, but the OD of these is 5.015", which is about 20 thousandths too big to fit.
Hillbilly boy
Reviewed in the United States on January 18, 2025
Each one measuring between .499 and .505 inches on od and length and inside dementions went a long the same amount of tolerance. NO COMPLAINTS. SEEMS to be a good value and didn't have to search local shops and pay more probably. Will be ordering more probably.
Hubert T griner
Reviewed in the United States on June 2, 2024
They were just what I was looking for
Robert Clark
Reviewed in the United States on March 5, 2024
These spacers will be used to help steady and center a 3/8 Bolt used as a lifting shaft on a bench rest stock. They are slightly larger ID then the is OD but it is just what I wanted. I am pleased with this purchase and if needed will buy them again.
kitchenleopard
Reviewed in the United States on December 4, 2024
This were very nicely made.
Elizabeth M.
Reviewed in the United States on October 19, 2024
This is what I needed for a diy drill guide for dowel joinery. Works fine.
Scotty B
Reviewed in the United States on September 29, 2023
Good lookin spacers. Size was on point, and the ends were very clean and level.
Scrapper142
Reviewed in the United States on May 19, 2023
Product was just as described and delivered on time. Good quality.
Recommended Products