Your cart is empty.
Your cart is empty.AMZCNC 1-1/2" Conduit Hole Size Knockout Punch Unit with Manual Draw Stud – (1.95" – Actual Hole Size)
Pedro
Reviewed in the United States on February 28, 2025
Make job easier
terry Paige
Reviewed in the United States on August 10, 2024
Great Quality and value for the money
Jeff
Reviewed in the United States on February 5, 2024
I used a step drill to create a hole for the press screw, and used this to make four holes in electrical panels. The holes were clean and smooth while the cuttings were easy to remove. There is no wear on the tool.
T. COTON
Reviewed in the United States on November 3, 2023
There is almost no easy way to drill 1-½ inch holes in metal in a tight space, this one is one of them. I needed to drill the metal framing in my basement to pull a rolex cable and the last hole on the left was so tight, I had to use a tight fit accessory on my drill bit for the pilot hole. Then I used this tool to finish the job, the tightest was done by hand with a ratchet socket wrench and the remaining where done carefully with an impact drill, super easy whether by hand or with the impact drill. Don't forget to lubricate the head so it will ease the cut. The broken lug is a must, could not be easier to empty the tool.
Recommended Products
$18.11
$ 8 .99 $8.99