Your cart is empty.
Your cart is empty.Product Description
KEY FEATURES:
- Coolant Temperature
- Male M12-1.5 to Female 3/8" NPT
- This adapts SBC and BBC 3/8" NPT coolant temperature sensors to fit LS cylinder heads.
Will fit sensors with up to .85" length, measured from probe tip to the outer edge of adapter. Most aftermarket gauges will use a 3/8" NPT thread adapter (usually included with gauge)
Inclusions:
1 x A-Team Performance Coolant Temperature Sensor Water LS Engine Swap M12 1.5 Adapter to 3/8 NPT Fittings Compatible with LS1 LSX LS3 179
Fitment:
Ls1
Lsx
Ls3 179
James D guy
Reviewed in the United States on June 14, 2024
I used a 3 wire sensor on this adapter for my LS swapped c1500 and temperature gauge on the truck works and reads Accurate. It’s a nice quality fit and works great for the price. It’s really easy to install.
sandra sander
Reviewed in the United States on May 12, 2024
the fitting was the right size and is going to work fine
George B.
Reviewed in the United States on December 2, 2022
Would buy again
Brenda K. Halaska
Reviewed in the United States on October 14, 2022
Son using on truck
Jimbo_mofo
Reviewed in the United States on June 28, 2021
The hole is too small for the sensor to fit through. And when intried to gently drill it large enough to fit, the threaded part that goes into the head broke off. Don't waste your money. Just drill and tap the head for a 1/4 inch npt adapter instead
Bradly Matsubara
Reviewed in Canada on March 3, 2021
Only received 9
matt rott
Reviewed in the United States on September 20, 2019
Fit great
Recommended Products