Your cart is empty.
Your cart is empty.This replacement carbide cutter fits SImple Woodturning Tools engraved with STH or SSNH. Check your tool for the engraving near the handle. 9/16 outside diameter, flat top. Screw is sold separately. Please contact us by asking a question below if you have any questions.
DJUNGLE
Reviewed in the United States on May 17, 2024
For the last few years I've made over 250+ bowls/ plates plus different pens using these carbide cutters. I have purchased these cutters a number of times and am very satisfied with them. I am able to rotate to fresh sharp edge when needed. I use several different cutters from this manufacturer and will continue to do so. Very satisfied.
ddh
Reviewed in the United States on May 24, 2022
I am not saying it is bad. It just doesn't have that 'knife cutting through butter " feel of the original. It's getting the job done though.
ELK
Reviewed in the United States on November 24, 2021
I’ve been using these cutting heads for 2 years now. Whether it’s pine oak cherry or walnut I always get a good finish with them. Highly recommend.
Sharon
Reviewed in the United States on January 19, 2021
Good value
Woodsmith
Reviewed in the United States on January 14, 2021
Product was exactly as described.
Raymond Pender
Reviewed in the United States on October 18, 2020
The cutter is ok, they all are only going to last so long when using them as much as I do. The value for money rating is low due to Simple making a tool that they are the only ones who make the correct size cutter insert for. They have it priced way above the cost of other manufactures inserts and it isn't any better. The square cutter tool they make has a size that will allow one to purchase inserts from another maker but not the round one. If anyone is looking for a round carbide cutter tool, do not by a Simple brand or you will be stuck only having to purchase thier over priced cutter insert. I would not recommend this tool to anyone.
michelle t svendsen
Reviewed in the United States on February 28, 2019
Works fine.
Bruceman
Reviewed in the United States on February 22, 2017
All their tools work great. Their replacement cutters are in line with the cost of other brands. I have been using their tools for some time never had a problem.
Wayne TAYLOR
Reviewed in Canada on February 13, 2017
I have recently developed a tool with the carbide mounted on the end of the tool. I have made two vases three bowls and really like the carbide tool It cuts the wood so smooth you can jump at least a grade or two in the sanding process. Thanks Amazon for pages on wood turning tools. I have used this service a number of times and will continue to use it. Thanks again Wayne A taylor
Recommended Products
$29.99
$ 14 .99 $14.99