Your cart is empty.
Your cart is empty.The i-Link series 2-zone circulator pump controller is operated by low voltage thermostats or any other low voltage controllers having an SPST switching action. The i-Link controller provides intermediate switching to permit up to 2 circulators and a boiler operating control in a multi-zone hydronic heating system. Intelligent Linking System (i-Link) allows unlimited zone expansion with additional i-Link controllers. Unique power surge protection to avoid damage to the unit and ensure continuous control operation. Dimensions: 6 3/8”(W) x 6 5/8”(H) x 2 3/4”(D)
Good as new at a lower price
Reviewed in the United States on November 20, 2024
This is a good device and is working as advertised. Easy wiring diagram inside
dob
Reviewed in the United States on January 17, 2021
The unit (SP-82, they use SP-83 main board for those units) worked fine for 7+ years (came with the house). When it failed one of the relays was buzzing (not sure which one). I powered the unit off and on. The buzzing stopped, but relay on the front panel board started clicking (1-2 clicks/sec). I decided to replace.The replacement went well, but beware, the terminals marked "ISOLATED END SWITCH" (24v, going to boiler control) are now at the top of the device. The "SYS PUMP" terminals (120v) ended up in their place at the bottom (if counting from left to right).When replacing the unit I connected the wires as they used to be and ended up with 120v fed to the boiler control. The 15A circuit breaker tripped, but fortunately there was no permanent damage and everything worked ok after reconnecting it the new way.
Sarb
Reviewed in the United States on December 26, 2019
Works great.
Cecil Henry
Reviewed in the United States on April 17, 2019
was a direct swap, the transformer in the old started to buzz and it was only time before it would of failed. works great on the 2 zones of in slab radiant heat we have in our auto shop.
J.R.C.
Reviewed in the United States on July 18, 2016
good product
Recommended Products