Your cart is empty.
Your cart is empty.
If you have any problems regarding BIGTREETECH CB1 heatsink for CB1 core board, please feeel free to contact us on Amazon. We have professional technical supports online to help you. There's no doubt that One-year warranty is 100% guaranteed.
STEVEN F.
Reviewed in the United States on February 6, 2025
i printed a louvered cover for my motherboard and this heatsink looks nice and does the job very well dissipating the heat correctly, was an easy install too.
Wayne Manion
Reviewed in the United States on February 5, 2025
In case you were wondering: this does not fit the CB2.The screw holes line up fine, but there are two components on the CB2 board that stick out and do not allow the CB2 heatsink to fit flat on the main chip.
kenneth rood
Reviewed in the United States on July 21, 2024
as advertised
T.Perraut
Reviewed in the United States on May 9, 2024
It’s holding using gravity plus the thermal pad.Mostly because the BTT Manta E3 EZ I use it with has some non standard mounting holes.Overall, you should use one with any CB1 and that make theys price much more expensive. That’s unfortunate.
NissanN3rd
Reviewed in the United States on March 11, 2024
Must have for cb1
Timothy A Stiel
Reviewed in the United States on October 27, 2024
Buy Buy Buy! CB1 processor board runs hot! This is a must.
Skiboy
Reviewed in the United States on August 7, 2023
Help keep the apu/cpu cool during prints probably not necessary but helped with temps for sure.
David
Reviewed in the United States on April 4, 2023
I have tgis and a raspberrypi 4. This is a GREAT alternative to my raspberrypi, its does just as good. Easy setup and fast. Just fallow the bigtreetech directions and your good to go
Recommended Products
$29.95
$ 14 .99 $14.99