Shopping Cart

Your cart is empty.

Your cart is empty.

Bstinay 60 Angle Diamond CNC Router Bit Granite Stone Engraving 6mm Shank Dia

4.6 (3) Write Review
Free shipping on orders over $29.99

$8.19

$ 3 .99 $3.99

In Stock

About this item

  • 【Angle】60 degrees
  • 【Size】Edge Width: 10mm/0.39" Total Length: 40mm/4.57" Handle Diameter: 6mm/0.24"
  • 【Material】The product is made of high-quality diamond, which is tough and durable, and has a long service life
  • 【Application】Generally applicable to soft stone relief such as marble, bluestone, sandstone
  • 【Note】Since the measurement is manual, the error of 1-2mm is within the normal range, which will not affect the use of the product


Product Description

60 Angle Diamond CNC Router Bit Granite Stone Engraving
60 Angle Diamond CNC Router Bit Granite Stone Engraving
60 Angle Diamond CNC Router Bit Granite Stone Engraving
60 Angle Diamond CNC Router Bit Granite Stone Engraving
60 Angle Diamond CNC Router Bit Granite Stone Engraving
60 Angle Diamond CNC Router Bit Granite Stone Engraving

Rob
Reviewed in the United States on February 10, 2025
Can't tighten the router chuck on it because it is a 6mm shank.A quarter inch chuck will not tighten on it.I wrap in in teflon plumbers tape and can use it some.When i can make that work it cuts stone very well (see photos)
Donald Harp
Reviewed in the United States on November 5, 2020
No it will not work in none of my routers it was supposed to fit a 1/4 in shaft and it is to small it just dropped out
Robert O
Reviewed in the United States on October 18, 2020
Just as discribed