Your cart is empty.
Your cart is empty.GENERAL REPAIR/MAINTENANCE FOR CAREFREE AWNINGS, replace old worn out or missing parts with Carefree genuine replacement parts. Bottom bracket, white, for Spirit/Fiesta awning.
Kumar
Reviewed in Canada on April 2, 2025
Worst product
Robert Joseph Kassel
Reviewed in the United States on February 25, 2024
Direct Replacement on my RV.
Customer
Reviewed in the United States on October 9, 2024
Replaced this for a broken bracket, matched exactly
TODD H
Reviewed in the United States on August 19, 2023
They were well made and a perfect fit for my awningGood quality part
Reyal
Reviewed in the United States on June 6, 2023
The media could not be loaded.
PAUL E DOMASKY
Reviewed in the United States on September 17, 2022
Delivery was quick, and the item was well packaged. Often, when you order a replacement item for something older, it takes some fiddling to get it to fit. Not with this. Simple five minute job.
Downeaster
Reviewed in the United States on July 20, 2021
Fit perfectly and allowed me to repair expensive canopy so it looks like new. Reasonably priced and quickly delivered.
Dan Sherwood
Reviewed in the United States on October 29, 2020
Looking for a metal, solid unit to replace a crumbled plastic OEM unit on my 2008 Jayco 24RKS travel trailer. The OEM support arms had a part number not recognized on the Carefree site, so I took a chance on visual and measurements presented for the product. OEM part had 2 screw holes, the replacement had 4 holes. I did not want to drill more holes, so I used the 2 side holes only.All went well, but the horizontal plane of the side holes is about 1/2 inch off. Too far to fit, but too close for re-drill, (weakened wood). The existing roof bracket is critical for "hard lock", so I had to move the stop nut, (crown not), down 2 notches. Unit too low there, so have to remember to notch it up about 9/10 of a notch and let gravity hold it before stowing. A workaround would be to grind a notch in the bottom of the upper slider for the crown nut to fit into, or forget the side holes and drill the top and bottom holes.
Terry McHugh
Reviewed in Canada on September 28, 2019
As advertised
Ross lee
Reviewed in Canada on September 28, 2019
Fits perfect
PGB
Reviewed in Canada on July 8, 2019
Good delivery time, project exactly as advertised and easy to install.
Dustin
Reviewed in Canada on September 20, 2018
Bolted on exactly where the old one was and clipped my awning in place perfectly.
Customer
Reviewed in the United States on July 18, 2016
We bought these to use mounted on the deck of the camper, so that when we open the awning, we can disconnect the rails from the camper and click them into these brackets on the deck to avoid have that diagonal rail on each end of the awning and create more of a 'room' feeling. They work awesome in this capacity. We used lag bolts/washers to attach them to the deck. Super easy to operates as the rail 'pops' right down into them without having to bend, and when you want to remove them to reattach to the camper, just use your toe to push the lever down and pull them out. These have made our awning more of a pleasure than a dread!
Recommended Products
