Your cart is empty.
Your cart is empty.Other Info: Slips over blowgun tube to keep your hand from sliding into the tips of the darts. The foam insert allows for the darts to rest tightly without damaging to points. Hang Packaged.
Lonnie
Reviewed in the United States on October 31, 2024
Must have if you have razor darts. Fits tight
jake
Reviewed in the United States on April 4, 2023
It does its job. Fits tight. Etc.It fit my 2 piece tim wells stock master.It is only a 1 pack. Which is disappointing. I was expecting a 2 pack like the other quiver pieces you buy. But it's ok I guess.
Richard S.
Reviewed in the United States on October 29, 2022
I have a Cold Steel Magnum Blowgun and this didn't fit. I used my caliper to measure, the OD of my blowgun is .866, the ID of this is .743. I know .123 inches isn't much, but it's enough to make sure this didn't fit. I have 2 starts, because of it did fit, it looks well made. The markings are exactly like the 2 I currently have on the blowgun.
Jason O.
Reviewed in the United States on August 24, 2020
FOR STANDARD MODEL ONLY (too small for professional model)
Jonathan Meadows
Reviewed in the United States on November 25, 2020
This FITS my Cold Steel 5ft Two Piece Blow Gun Perfectly and FITS the other .625 cal standard models... WILL NOT FIT the 4ft professional model
wrknnwf
Reviewed in the United States on September 22, 2017
Really like having the extra protection. Slightly loose on my big bore, but a wrap of duct tape helps.
Art Ramon Paintings
Reviewed in the United States on December 31, 2013
I use two of these on each side fo the quiver to keep from snagging the pointy darts I have placed in alternating directions.
Recommended Products
$179.95
$ 81 .99 $81.99