Your cart is empty.
Your cart is empty. - Brand new with high quality
- Rated Voltage: DC5V-12V, 4-Phase
- Reduction Ratio: 1/64
- Step Torque Angle: 5.625 /64
- DC Resistance: 200w+- 7% (25 C)
- Insulation Resistance: >10Mw (500V)
- Insulation Grade: A
- No-load Pull in Frequency: >600Hz
- No-load Pull out Frequency: >1000Hz
- Pull in Torque: >34.3mN.m(120Hz)
- Detent Torque: >34.3mN.m
- Temperature Rise: - Noise: - Board Size: Approx. 40X21 mm
- On-board XH-5 P socket.connect 28BYJ-48 Stepper Motor direct
A Em
Reviewed in Canada on September 12, 2024
The media could not be loaded.
ElectroBoogie
Reviewed in Canada on August 5, 2024
Working great, followed the first demo i could find with the built in generic Arduino code for steppers on my ESP32. Pretty basic stepper motor driver setup to explore the topic. Not bad to setup with 4 pins off the MCU to control the driver array. You may want to budget some more pins for limit switches to provide start or stop endpoints as its happy to step away, but it doesn't know where its absolute position is in the world. Also, a dedicated power supply for the driver board is recommended, but the build in 5V rail on the ESP was enough to step it for testing.
MrMakesALotOfStuff
Reviewed in the United States on February 13, 2024
While the DEVMO 28BYJ-48 Geared Stepper Motor and ULN2003 Driver Test Module Board performs as expected, there are significant design flaws. The incorrect photos led to disappointment, as the pins were located on the topside, rendering it incompatible as a hat and unable to plug directly into a breadboard. Although I managed to resolve the issue by resoldering, it was a laborious task for a relatively inexpensive part. Despite these drawbacks, once properly configured, it functions as intended.
Mike W.
Reviewed in the United States on January 16, 2024
The media could not be loaded.
Jake
Reviewed in the United States on December 30, 2022
Do not buy if you are looking to get the version with breadboard Pins
Jeepin
Reviewed in the United States on November 25, 2020
The image shows that the pins are installed on the bottom of the board (opposite side from the components and motor plug). The item I was sent has everything installed on the top of the board. My plan was to use this with a solderable breadboard, which will not work with this configuration.
Recommended Products
$99.99
$ 45 .99 $45.99