Your cart is empty.
Your cart is empty.Product Description
DIY CNC Controller Card, USB 4-Axis Linkage Stepper Motor Motion Control Card, 100Khz Motion Controller Card Breakout Board for CNC Engraving
Support for limit switch
Maximum step-pulse frequency is 100KHz, which is suitable for the servo or stepping motor
Support automatic probe tool
shaun
Reviewed in the United States on May 12, 2024
It's great for the price I would buy agin.
Pithungo K.
Reviewed in India on March 25, 2024
Received a good working Unit.
Dawne Short-Scott
Reviewed in the United States on November 30, 2024
I used this to replace an old outdated parallel interface card on an old 3 axis cnc controller and the installation was easy and straight forward. I was amazed at how smooth the motion was when used with the Mach 3 software. Great value for the money.
hans
Reviewed in the United States on November 29, 2024
I mad a sweet wood cnc table and this breakout board works perfectly. Took a little figuring out how to set my computer’s software but when it’s don this thing works amazing.
Tom Tran
Reviewed in Canada on October 7, 2024
Got this board to replace an old parallel BoB from my Emco F1 CNC from 1985. Just follow the instructions on mycnc and you should have your Mach3 drivers and settings properly set up. The controller is IM483 and needs their 5V opto coupler input to hooked up to the RnR board 5V output. I ran the machine on Windows 10 with no issues. Now my F1 is back from the dead.
Customer
Reviewed in the United States on September 20, 2023
Not smooth and the numbers on this board do not match the advertised pic.
Customer
Reviewed in Canada on August 28, 2023
I have a 15 year old home made CNC mill I wanted to run, but it was running on a parallel port.I played with an old Pentium 4 with a parallel for 3 days without luck.I installed this card and IT WORKED, right away took maybe 15 minutes and no more windows XP.Plug and play, Windows 10 installed a native driver.Do a search for Mach3 USB Interface Board and follow the instructions. You need the dll and xml files.When I first loaded their xml I couldn't move anything I change the jog mode to cont and turned off inputs for X Y Z Home and it worked.Lightning fast delivery, best price around, what more could you ask for?Thanks a lot!
Sidney Clinkscales
Reviewed in the United States on August 16, 2023
I like it and it works great except I have not been able to get the outputs to work correctly, the output signal to one output pin causes all outputs to respond with the same signal. Using MACH3, Windows 10 on HP PC.
Macster
Reviewed in Canada on February 2, 2023
The media could not be loaded.
Ck transport
Reviewed in the United States on December 18, 2023
This board paired with the computer just fine. The disc has the Mach 3 software to install on your computer. Everything works as it should.
Mike
Reviewed in the United States on April 23, 2023
No issues. Works as intended. Seller followed up to make sure all was well. Was much appreciated.
DmA,IL
Reviewed in the United States on April 1, 2023
Getting everything hooked up and running with Mach3 took a little while but is not very hard. Numerous videos on youtube showing this exact board and how to get it working with Mach3!
gamal abd
Reviewed in the United Arab Emirates on February 7, 2022
I purchased this controller card , but when I connect it to the pc or the laptop windows can’t recognize it , although it is mentioned there is no specific driver need to be installed
Recommended Products