Shopping Cart

Your cart is empty.

Your cart is empty.

Dynamite Tazer 37-Turn 380 Brushed Motor DYNS1208 Electric Motors & Accessories

Free shipping on orders over $29.99

$8.99

$ 3 .99 $3.99

In Stock

About this item

  • Dynamite Tazer 380 Brushed Motor, 37T: 3.5mm Bullet, DYNS1208


Dynamite Tazer 380 Brushed Motor, 37T: 3.5mm Bullet, DYNS1208


Thad Lietz
Reviewed in the United States on August 17, 2024
Almost too powerful for my application but that's what the throttle is for.
Neightn
Reviewed in the United States on February 13, 2024
Works great. Just like the original.
Customer
Reviewed in the United States on November 8, 2024
The shaft on this motor is 2.33mm...... not 3.5mm as advertised.
Blake
Reviewed in the United States on November 7, 2024
I bought this to replace the 3rd burned out garbage arrma mega 380 motor that come stock in the Grom platform.*This motor is a lot slower than the factory 28t 380 motor. * For anyone that is curious this motor is about 2700kv. It spins 26780rpm @10vThe Tazer 25t is a great higher speed motor option! *With proper gearing so it doesn't overheat.BUT for small tracks with low speed tight turns where off throttle response is key this motor with stock 18/59 gearing worked amazing! After multiple batteries it never got too hot. I could hold my hand on the cooling fins for at least 5sec. Couldn't say that for the stock motor after only 30 seconds of driving.
David Fors
Reviewed in the United States on October 14, 2024
Fix my Fitbit screwdriver motor was burned out replace the new motor it works great now cuz they do not sell them anymore
Dusty R
Reviewed in the United States on April 30, 2024
Worked great in my danchee rc car much more powerful that what came stock in it
G. Pierce
Reviewed in the United States on February 1, 2023
Have only tested it. Works fine with my ESC. Will be used in a displacement hull boat model, African Queen. 37 turn motor should provide correct speed.
Tenacious Tee
Reviewed in the United States on April 23, 2022
The best upgrade you can do for the ridgerock. You will need 80a esc as well as 8t pinion gear along with minor trimming of the shaft length but you can squeeze the bad boys into those axles with some care. Highly recommend for you danchee enthusiasts looking to kick things up a notch.
Recommended Products