Electric Meat Injector Gun Pump with Hose - 70W Stainless Steel Marinade Injector Syringe, 10 Needles for BBQ, Turkey, Pork, Beef - Perfect for Home Grilling, Family Parties & Outdoor Cooking

• Quick Connect Plug: After inserting the connector, you hear a click and it's installed. When removing, hold down the ring with your hand and pull it outward.
• Stainless Steel Filter Mesh: Please ensure that the marinade completely submerges the filter screen.
• Cleaning and maintenance
• After each use, please clean the pipe with clean water, just like injecting marinade, until the water sprayed by the syringe is no longer cloudy. This is because the marinade will easily corrode the pipe if it stays for a long time.
• ( If some parts of the marinating syringe leak water during use, please tighten them again and wrap some raw tape around them before continuing to use. )

What kind of marinade should be prepared?

• Please be careful not to use hot marinade water, which will damage the machine and hose.
• It is recommended to use a thinner liquid marinade rather than a thicker one, such as butter.
• Please do not use a thick marinade (such as butter), which will block the needle.
• NOTE: The particle size of the marinade should be smaller than the pinhole to avoid clogging the needle.
• Ensure that there are no large particles in the marinade to prevent the host from blocking.
• Attention: 1. Please ensure that the marinade completely submerges the filter screen.
• 2. The container for storing marinade sauce water should be placed on the same level as the meat injection pump, so that the height of the motor and the container are consistent, not one high and one low.

Pierce the needle into the meat and then press the gun handle to add the marinade.

• The marinade injector doesn't work and no marinade gets sucked into the tube. what should I do?
• 1. Check whether the meat injector is installed properly
• Please kindly check the installation video on the details page.
• 2. Check whether the power adapter and motor are working normally
• First, check whether the indicator on the power adapter is on; If the light is on normally, check whether the motor works (the motor will have a humming sound when it works). If the motor does not work, take off the needle first, and then turn on the power switch to see if it works. It may be the needle blockage caused the motor does not work.
• 3. Check whether the needle is blocked
• If the adapter lights up and the motor works but does not suck water, please put the filter screen in a basin of water without exposing the water, take off the needle, and press the handle switch for about half a minute; If there is still no water coming out, please turn off the power switch, press the handle switch while using the mouth to suck a few mouthfuls of water from the outlet until you see water flowing from the outlet, then turn on the power switch to see if it works.

Cleaning & Maintenance:

1. How to extend the service life of marinade injector?

It is recommended to turn off the machine directly after cleaning it with water cycle after each use, you don't need to empty the water in the machine, keep some fresh water in the machine and store the machine.

2. What should I do if I don't use the meat injector for a long time?

After use, clean the machine with fresh water cycle and keep the fresh water in the machine without emptying. When you use it again, just empty the previous water and use new fresh water.

3. What should I do if the cured meat injector doesn't work?

The needle may be clogged, please try a new one.

Completely submerge the stainless steel strainer into the marinade.

Don't put the container for marinade in a low place, otherwise it may exceed the lift of the pump and cause insufficient power.

If it still does not work, please follow the video instruction to exhaust.