Your cart is empty.
Your cart is empty.10 each 2.2k ohm resistors. 1/2 watt. 5% tolerance. Flame retardant coating. Lead free & RoHS Compliant. Cut tape packaging.
Darren Rolston
Reviewed in the United States on February 16, 2025
As advertised
CC Rider
Reviewed in the United States on August 29, 2024
I used this resistor to bypass an oxygen sensor on one of our automobiles, following a performance modification. It works perfectly. No more check engine light and the engine runs correctly now. The leads tin up well, using ordinary electrical solder, and the value markings are clear and permanent.Good purchase...
James Fullerton
Reviewed in the United States on June 26, 2024
These worked great for my need. Nicely packaged and fixed the problem I was having with the key pass on a Chevy express.
Todd M Peterson
Reviewed in the United States on March 17, 2024
Arrived promptly.
Darren
Reviewed in Canada on December 4, 2024
What I ordered! Older Nissan vehicles used a resistor for voltage control of the distributor coil. It starts at 12 volts, and then the ECM drops to 9 volts to keep the coil from overloading. And thank you Amazon for how fast I got this!
Joseph Prema
Reviewed in Canada on December 29, 2024
Met my requirements
richard,,
Reviewed in Canada on December 21, 2024
It Work for my project
Neil D
Reviewed in Canada on December 16, 2024
Ordered to stop hood latch alarm on a Silverado. Worked perfectly
Rejean Lefebvre
Reviewed in Canada on November 9, 2024
Bonne qualité du produit et tres bon service
Heather
Reviewed in the United States on September 5, 2023
They arrived in a package that was huge for the size of the resistors but other than that, they arrived in great shape. We only needed one so we gave the rest to a buddy as extras in case he needs them.
Doug Sitch
Reviewed in the United States on May 22, 2023
no problem
Jimmii
Reviewed in the United States on June 26, 2022
Was recommended to use this when doing the catless up pipe upgrade in my 2002 Wrx.In theory it should keep the check engine light away since you are removing a whole sensor in the exhaust.So far I’d say it works, I have not seen any check engine lights, car runs perfect, no limp mode or anything. Driven the car about 200+ miles with the resistor mod so far.Used a rubber glove thumb to cover the open wiring where the original sensor was unplugged.Though I have not tried it without the resistor mod. So, I wouldn’t know if there is or is not a check engine light that comes up.There’s been some debates on old forums if it does or not so, I’m not sure. But I played it safe and grabbed these.
Recommended Products
