Your cart is empty.
Your cart is empty.Faria's Chesapeake White-series provides a great look to your boat's gauge panel. Each Chesapeake White gauge features an attractive perimeter-lighted white dial with stylish blue and black graphics. It offers a polished stainless steel bezel, a contoured black pointer, and a domed glass lens. The size 4 gauge requires a 3.375" (85 mm) mounting hole.
W. P. A.
Reviewed in the United States on July 23, 2022
My factory tach finally died 20 years so I replaced it with the Faria. It fit perfectly and connected just as my original so I’ma happy boater.
Eric
Reviewed in the United States on February 9, 2022
Wired up easily, fit the existing dash hole. ***Works perfectly, great accuracy.Bought in July 2021, March 2022, not working properly. No engine or wiring problem. The needle floats up and down as though the rpm’s are changing, swinging….not accurate any more? It has lost any accuracy. I am disappointed. It appears the return window has expired? Maybe the manufacture could replace the tachometer? The trim, fuel and voltage gauges are working well and are also new Faria Chesapeake.
KP in Texas
Reviewed in the United States on November 18, 2022
The product is very stylish and looks good in my boat. Very easy to install, just follow the easy to read instructions. It connected easily to the existing wiring harness for My 1986 Mercury 150HP Black Max XR2 motor. Very accurate but will have to wait to comment on durability as I just installed it.
Sarah M.
Reviewed in the United States on November 15, 2022
I purchased a used boat. The tach was not working. I purchased this tach to replace the white tach that was in the dash. This tach fit perfect in the hole of the broken tach. The back of the tach was wired the same as the broken one. I replaced the tach with all the same wires. The broken tach was set to the #5 setting. My motor is a 2003 Mercery 115 hp 2 stroke 4 cylinder. The direction said it should be set to #2. Well number two was not right, showing 4 k at idle and all over the place. I changed it to #5, and it is spot on for my motor. I added a few photos, hope this help other folks install this tach.
SheepDad
Reviewed in the United States on April 26, 2022
Great Product. Easy install. Looks Great. White backlight is perfect intensity and does not hamper vision at low light or no light.
MASH
Reviewed in the United States on July 13, 2021
Product looks nice. Directions are scant. Currently tach works up to 4500 rpm on my 1994 Mariner then it starts bouncing to zero and back up. Could not find my motor on the very small short chart so I had to set it up based upon old tach and hope for the best. I've reached out to the mfg for help. Well see if they respond. I'll update if they do.
Bill B
Reviewed in the United States on September 26, 2020
Matched the old one perfect. Hooked it up and performs great.
rdmjr
Reviewed in the United States on September 5, 2019
opening was 3 3/8 inches, hookup was same as my old faria unit from 1999. works like new.
Recommended Products
