Your cart is empty.
Your cart is empty.FelPro gaskets offer 100% vehicle sealing with applicationspecific materials to give you sealing solutions with the performance and durability professionals trust
steven
Reviewed in the United States on December 19, 2024
fit my 99 4runner 3.4L valve covers perfect fixed a terrible oil leak
Jl
Reviewed in the United States on August 9, 2023
The gasket was good quality and fit perfectly. The spark plug seals are not as good as original one. Might not last as long.
Mike
Reviewed in the United States on March 13, 2023
Did my valve cover gaskets this weekend. Took me a while but managed to do the job myself. These gaskets were very well formed and slotted into the valve covers tightly, so they didn't fall out while I was struggling to get the covers in place. Would definitely buy again, but hope I don't have to.
johnnyd
Reviewed in the United States on April 2, 2022
Fixed my valve cover leak, only been couple hundred miles but no issues yet, everything for perfectly. Will update if any problems arise down the road. But pleased so far
4runner808
Reviewed in the United States on November 5, 2020
These fit perfectly for my 3.4L 1999 Toyota 4Runner. Even though Amazon says it doesn’t fit, but it’ll fit any 3.4L 5VZ engine
Lukas
Reviewed in Canada on September 14, 2019
Good gaskets.
grassmower
Reviewed in the United States on November 12, 2014
I didn't check closely - this set did NOT have the seals for the bolts?? Why not?Had to get them from NAPA $1.10 per bolt extra.
Lee
Reviewed in the United States on July 17, 2013
The thing about gaskets is that they are either a 0-star (don't work) or a 5-star (work well). If it doesn't work well, it doesn't work at all. Kind of like being slightly pregnant... But I digress.The gasket material seems to be identical to OEM. The dimensions are 100% identical to OEM for gaskets and grommets. It helps to know some tricks for installation to use this set since there are no meaningful instructions included. This specific gasket does not use a seal spray to attach to the valve cover (IIRC, this is stated on the box) before final installation, but of course uses RTV to properly seal critical points. For the RTV application, you must refer to a service manual - that is not instructed with this product.Installation of grommets can be tricky if you don't source information from someone who has done this before. In the 3.4L valve cover, you must bend a metal tab to remove the old grommets and install the new ones. Tip for installation of grommets (and most any round gasket): Place in freezer for a short period of time before placing into valve cover holes (I did this in a -20F freezer for about 30 minutes; then I wiped the grommet's outer edge with a rag soaked in WD-40 and quickly & carefully placed the grommet into the hole). R&R of all 6 grommets can be done in under 10 minutes by following these instructions and having some very basic experience with pulling rings and gaskets (I pulled my old gaskets with a screwdriver instead of a gasket puller, but I'm a bit cavalier like that sometimes).The price of this is enough lower than the Dealership price (especially since it includes all 6 grommets) to say this is a must-buy.
Recommended Products
$13.59
$ 6 .99 $6.99