Your cart is empty.
Your cart is empty.Fits Fleck 5600 Softener and Filter Controls. Fleck Replacement Part 60125. This is not an OEM part.
Steven
Reviewed in Canada on September 14, 2024
I have a DuroSoft water softener which is made up of different Fleck parts. The 5600 seal and spacers fit perfectly although the piston is different from the 5600 rebuild kit and my brine valve is from the 7000. This was the least expensive option to fix my water softener. It now goes through a full cycle without getting stuck and no dreaded Error codes.
BRM
Reviewed in Canada on August 15, 2024
Just like the original! What's not to like?
Der freundliche Konsument
Reviewed in Germany on July 4, 2024
Die Dichtungen sind ein Ersatzprodukt und nicht original Fleck.Sie passen super und sind einbaufertig geliefert (mit Silikonfett eingerieben).Sie passen nicht nur auf das Fleck Ventil 5600 sondern auch auf das Ventil 6650,wahrscheinlich auf alle Fleck Ventile mit Kunststoffkörper. Zur Orientierung: Der Durchmesser ist 40/ 25 mmEs gibt bei Youtube übrigens einen Anleitung zum Zerlegen des Ventils Fleck 5600 (Praxair Water Academy)Das kann jeder Laie machen.Man muss etwas Kraft aufwenden, weill die Verbindungen mit der Zeit festgehen.
Bo T.
Reviewed in Canada on December 4, 2024
Doesn't work! Still leak after replacing them.
Brad
Reviewed in the United States on November 17, 2024
These worked fine. As a pointer, watch a DIY video on YouTube (there are plenty) and keep the seal/spacers all facing the same way as how they’re packed. They are pre-greased but I added more. Use the opportunity of having your unit disassembled to clean up all the valve and drain opening to extend life. If you want to bark about the $26 for rubber just know you won’t find them cheaper and a new setup is $600.
Recommended Products
