Your cart is empty.
Your cart is empty.An ACDelco GM Original Equipment Brake Light Switch is a GM-recommended replacement for your vehicle’s original component. It is electrically powered and causes the brake lights to engage when the brakes are applied. This original equipment brake light switch has been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors.
ronald racoobian
Reviewed in the United States on March 19, 2024
good product at fair price.
Customer
Reviewed in Canada on March 10, 2024
Part number is a direct match .and part is identical match as per box and part number this is Genuine GM
SimpleSimon
Reviewed in the United States on April 5, 2024
Fixed my no brake light problem.The 4 star on installation is not the unit's fault -just a note to folks to not expect it to be as simple as it would seem,especially because you're on you back under the dash with no roomto move or get fingers where you need to have them.But again - NOT the switch's fault.
lowell minnick
Reviewed in the United States on July 26, 2023
factory correct part
DaveH
Reviewed in Canada on August 20, 2022
Ordered this switch. It came very fast and was a perfect fit. Works perfectly!
Customer
Reviewed in the United States on July 7, 2022
Not the easiest install but i have brake lights again!
Theadore Groholske
Reviewed in the United States on December 19, 2022
Except for the retainer clip, it was easy to install!
t han
Reviewed in the United States on December 9, 2021
Just as described, works as described and mounts exactly as it should. Typical GM quality.
Aram
Reviewed in the United States on April 18, 2021
This OEM replacement works flawlessly. Saved well over $100 installing it myself. Took all of 10 minutes to replace and I now have brake lights that work!
pogth
Reviewed in the United States on March 19, 2019
I have held off on writing reviews for most of the products I have ordered over the past few years to give myself ample time to really test the products and see how they hold up.Bought this for 2004 Chevy Blazer Extreme when I finally found out after a few months my break-lights were out ( yeah cops behind me at times stopped and people no one said anything!). Has been working fine every since installed. I took video I believe of the position, but will have to look for it. It is simple just remove clip and slide of and unplug. There is a bar in the middle of the outer part close to the clip that pushes the sensor in when the brakes are at rest that needs to go back in once you get the first two holes on the bar and before sliding the last hole over the bar and applying the clip. Hope this helps.God Bless.
Recommended Products
$38.84
$ 18 .99 $18.99