Your cart is empty.
Your cart is empty.Product Description
G2R ATS Usage Precautions:
1. 220V ATS should not be used with a voltage lower than 185V, otherwise the coil may burn out.
2. 110V ATS should not be used with a voltage lower than 90V, otherwise the coil may burn out.
3. The switch cannot be manually switched when in automatic mode, otherwise the coil may burn out.
4. 4P ATS ensure correct connection of phase sequence，otherwise the contacts may burn out.
When both A and B have electricity, priority is using A Power
NOTE:
1. Manual/automatic operation can ensure the opening and closing performance of electrical operation, but in manual operation , cannot be assured due to the different opening/closing speeds of the operators. In manual operation, there's possible for excessive silver alloy loss . Therefore, the selector switch should only be pulled to the manual position after all power has been cut off for inspection and maintenance of the operating system and contact information.
2. Normally, pull the selector switch to the electric position. When manual operation is required, pull the selector switch to the manual position. After manual operation is complete, pull the selector switch from the manual position to the automatic position. The control circuit TSE is immediately energized. After the change over is completed, the internal switch will damage the coil in the control circuit, and the coil can work normally at 85%-110% of the rated operating voltage. Too low input voltage may cause the coil to overheat and burn out. Attention!When manual operation the mode selection switch must be in "manual" position.
Dave
Reviewed in the United States on May 8, 2024
Transfer switch's work well when purchased. After a few days 2 of the 3 failed.If you have a vital circuit, these are not the ones to buy. To bad because these are perfect size and Din rail mounted.one of these is working currently. All three were doing the same 120 voltage and 15 amp. load on different circuits.There is probably better reliability out there to purchase.
Kacie & Ross
Reviewed in the United States on May 29, 2024
It will switch to source 2 but it will not switch back to source 1 unless I do it manually.
Giacomo Spagnolette
Reviewed in the United States on February 29, 2024
The media could not be loaded.
Jason
Reviewed in the United States on November 4, 2024
This switch failed minutes after installing.Dissecting the switch revealed very poor quality parts and construction.It's unfortunate because it would be a great configuration if the quality was better.
Recommended Products