Your cart is empty.
Your cart is empty.We are providing High quality and durable items. If you have any question feel free to contact us, our team will help you 24/7
D. Patel
Reviewed in the United States on September 21, 2024
Ok set. Gets the job done. One of the punch broke at the tip. The side wall just bent and seared off.
M D Morgan
Reviewed in the United States on September 2, 2024
Bought by mistake as I wanted flat finish punches but will work good as starter punches
Thomas Russell
Reviewed in the United States on June 7, 2024
I recently purchased a Winchester punch set from Amazon and I really liked it. Came with many size punches (Steel/Brass/Plastic) for all your needs, but it did not have any starter punches. This really completes the set and makes it MUCH easier when starting a roll pin. If you do your own gunsmithing, you need these.
Walt B
Reviewed in the United States on May 2, 2024
The starter punches work great especially for AR assemblies. These are invaluable for putting the pin in on the upper receiver for the mud door and forward assist pins. I've only used them twice but they seem durable and are great value for the money.
PTN01
Reviewed in the United States on October 2, 2024
If you ever tried inserting gasblock roll pins in without a starter punch, you know how much of a headache it truly is. After doing this on many gas blocks over the years, I finally bought this kit. My only regret? Not buying them a decade ago. Literally took minutes to install.
Customer
Reviewed in the United States on October 19, 2024
Just keep this set in my range box. Roll pin’s sized perfectly.
BC
Reviewed in the United States on October 18, 2024
This set worked great, worked as they should, thank you.
JC
Reviewed in the United States on February 2, 2023
For clarification, these are starter punches for roll pins. The sizes 1/16, 1/8, etc., refer to the size of the roll pin, which seats inside the hollowed end of the punch, allowing you to start to drive the roll pin into its hole. You will need another set of punches the actual diameter of the roll pin to drive the roll pin all the way in. The diameter of the thinnest punch with a 1/16-inch hollowed end, for starting a 1/16-inch roll pin, is about 1/8-inch. The pins are short, but are only designed to be starters. The quality seems good, but if you use these for anything other than starting, you'll mushroom the end of the punch, at which point it may no longer be useful as a starter.
Recommended Products
