Your cart is empty.
Your cart is empty.
When you install the solar panel cable on your RV or boat? You need to make a cut in the roof of the RV. To avoid making unsightly and potentially leaky cable entries, use the Haoguo Solar Cable Entry Gland to cover the area, making it fully waterproof.
Installation steps:
1. Peel off the surface of the 3M waterproof tape at the bottom of the lower cover
2. Stick to the roof and fixed with screws
3. Peel the surface of the bottom 3M waterproof tape, pass the cable through the gland and pull it into the RV interior
4. Press the upper and lower covers together and secure them together by the buckle between them.
Specification:
Color: White
Size: 4.4*3.6*1.57 inch
Bottom cover size: 3.3*2.5*0.1 inch
Material: ABS plastic
Suitable for: All Cable Types 2mm² to 6mm²
Roger Vargas
Reviewed in the United States on May 9, 2024
Good quality
Customer
Reviewed in the United States on December 25, 2024
Este cubre cables lo pedimos para un trabajar diferentes partes de la camperización de una van. La misma se recibió según lo ordenado y trabajo excelente.
Customer
Reviewed in the United States on February 5, 2023
Easy to use. drill hole in roof, run cables through gland and stick and screw. Done in 10 minutes.
Skizzy
Reviewed in the United States on January 3, 2023
It is super easy as long as you don't take the nuts apart and try installing them backwards
scott p.
Reviewed in the United States on January 26, 2023
Easy nice product
Dick Approved
Reviewed in the United States on October 25, 2022
I liked it gave me everything to install it but the silicone.
Retired Nomad
Reviewed in the United States on May 18, 2020
... nice , it has 3m tape and screws ...
The dad😎
Reviewed in the United States on December 7, 2020
Great value and quality
Recommended Products
