Your cart is empty.
Your cart is empty.Product Description
xipoqix Hood Insulation Pad Compatible with 2022-2025 Ford Maverick
xipoqix hood insulation pad is compatible with 2022 2023 2024 2025 Ford Maverick.Please check the vehicle model thoroughly before making a purchase.It is made of high quality PET felt material. It has good sound insulation and heat insulation. It is highly elastic and fits perfectly into the hood.
Friendly PET Felt
The soundproof protective pad compatible with Ford Maverick hood insulation pad is made of high quality PET felt material. It has good sound insulation and heat insulation. It is highly elastic and fits perfectly into the hood.
Detail Presentation
Flame Retardant
Soundproof protective pad is flame retardant and heat insulating, protecting the hood from engine heat.
Special Design
1:1 according to the original car design, leave the buckle holes for installation.
Wear-resistant
PET felt material has good wear-resistant and will not be easily scratched.
Professional Design
Special small clasp are installed and fixed without the need to drill the car.
Lydia
Reviewed in the United States on March 28, 2025
Exelente
Ariel K.
Reviewed in the United States on March 28, 2025
I didn't use any of their attachment hard ware it's really bad and can damage hood. SOLUTION.. The attach top two hood holes use 16mm plastic snap in hole plugs with a 1/4 hole drilled in them then use a Toyota type nylon push pin fastener. FOR the Two far right and left long slots in the bottom of hood, I used the white split back nylon square license plate nuts with a SHORT metric bolt 10mm head about 1/2 " long or less with a washer that holds the pad. As the bolt enters the nylon nut put in the slots ,the bolt expands the two tabs that locks it in. The two lower holes about 4" apart i used a 12" x 1/4 tie wrap .Go thru the pad then 1st slot ,then inside the hood bracket then out the second slot ,then thru the second hood pad hole ,pass thru other end of tie wrap... I tucked the end of tie wrap in indent in the pad ...it all looks factory ..Hope this helps all the fasteners are at hardware store ..like Ace..make sure the 16mm hole plug are snap in type .I used a small socket for a sizer to get right size..
HLB
Reviewed in the United States on March 12, 2025
This really looks great under the hood, helps a little with sound suppression and protects the paint on the hood surface.
Ian McDonald
Reviewed in the United States on February 4, 2025
Doesn't fit. This is being polite. This tries to make you use odd holes with too long bolts while trying to hide washer hoses. Do not buy! I would have returned if I hadn't thrown out the box accidentally. When someone has to access a washer hose and removes this, the fasteners will fall into the hood skeleton. Then rattle. Just don't. Buy a Lincoln engine cover instead if you don't like the high pressure pump tick.
W.F.
Reviewed in the United States on February 27, 2025
It’s great, easy install
Jaime R.
Reviewed in Mexico on February 26, 2025
Queda perfecta al espacio del cofre, muy bien…👌🏻
Danny L. Chandler
Reviewed in the United States on January 9, 2025
Easy to install and really cuts down motor noise
Curtis Abrams
Reviewed in the United States on January 3, 2025
Very easy to install, product reduced engine and road noise and looks great, definitely recommended.
Good
Reviewed in the United States on October 26, 2024
Good product. standard PET felt construction. Could use a few more attachment points. Would recommend.
Recommended Products
$38.99
$ 18 .99 $18.99