Your cart is empty.
Your cart is empty.Inert Gas "Y" Valve Argon Western # 411
Dean Cotton
Reviewed in the United States on June 1, 2023
Allowed me to connect my mig to my Tig tank so I don't have to switch lines back and forth.
Brianleerettmann
Reviewed in the United States on May 7, 2023
I've used this product at work for 3 years. It's great for splitting inert gas processes. Without the hassle and wear on brass fittings. The idea must have came from oxy acetylene cutting torch functions. So don't you pass up this product.
William L.
Reviewed in the United States on December 31, 2022
Works great for my needs no problem no leaks would buy thanks
T.W.
Reviewed in the United States on June 10, 2021
Great for tig welding. One hose to your torch, one hose to your purge. That is what it do.
Jim Boyd
Reviewed in the United States on May 16, 2021
Allowed me to connect my both of the welders I use for aluminum to a single argon bottle. Now changing from MIG (spool gun) to TIG takes only seconds.
Q. Smith
Reviewed in the United States on July 2, 2019
Works good! Just what I’ve been looking for. No more disconcerting one hose to connect another hose and the back again.
Ion
Reviewed in the United States on July 17, 2019
Solidly made. I use it to run separate gas sources (Ar and Ar-CO2) into my multifunction MIG/TIG welder. Eliminates need for switching hoses. Only ding would be that there is not a six-sided "nut" cast into the female ends of the "Y" but there is a parallel flat cast under the valve knob that you can grab with a crescent wrench and stabilize when tightening. No leaks detected. Taped labels onto knobs.
S. Shogrin
Reviewed in the United States on July 1, 2015
Just what I needed to hook up a C25 and an Argon tank to my Everlast MTS welder. Easy to select gases for each process, or mix for higher Argon percent.Quality product, valves are solid, no leaks.
Recommended Products
