Your cart is empty.
Your cart is empty.The internal CV shaft removal tool has a 2-inch opening and a depth of 2.5 inches to meet your needs.
jeepster09
Reviewed in the United States on June 27, 2024
Used large prybar/screw driver instead. Tool would not fit in between flange and joint. Save your money and use pry bar.
boydden
Reviewed in the United States on May 24, 2024
The tool worked perfectly with my slide hammer tool.
Jay
Reviewed in the United States on February 18, 2024
Would have given 5 stars but for the fact I had to run a 5/8 18 tap to clean up the threads so it would screw onto my slide hammer.
Kimberly Fleetwood
Reviewed in the United States on November 21, 2024
I think this would work for most applications, just not for mine. Product seems to be made of good material, it just wasn't the correct size that I needed... Plus the fact it is a little bulky
Mikel Hart
Reviewed in the United States on October 31, 2023
Does as it should. For really stuck parts be ready to hammer hard and allot. Use allot of wd40
Richard
Reviewed in the United States on January 15, 2023
get a hammer, beat it off
Recommended Products
