Your cart is empty.
Your cart is empty.
Removing and installing a headless stud is always a tricky task. This special tool kit is here to help. This kit helps remove and install studs without damaging threads.
Removers are two parts joint together to allow itself counter lock on the studs.
Installers have an internal steel ball that allows the installers to detach the stud once it is properly installed.
Sizes included -
- M6 x P1.0
- M8 x P1.25
- M10 x P1.25
- M10 x P1.5
Alexander Lichstein
Reviewed in the United States on June 9, 2024
I would say you get what you pay for with this product. They are perfectly fine for light use, or for easy studs, but when you need to pull tough or delicate studs, these will not do the job. The design is fundamentally similar to a double-nut arrangement where cranking on the tool pulls on the threads *axially*. This means the more you crank down the tool, the more it wants to strip the threads. meanwhile, if it's too loose, it ends up slipping and won't pull the stud.I ended up spending about 5x more for the Snap-On version of this set (MSKM10) which uses a "collet" design that *squeezes* on the threads radially as you crank it down. In other words, the tighter you make it, the *more* it protects the threads. I believe it's the only one of its kind, so I really had no choice, and I believe is the very best for pulling the head studs from an air-cooled 911 engine.Again - nothing wrong with this tool given the right expectations, but if you're planning to pull tough studs, and would like to preserve the threads, you really have to pay the bigger bucks for the right tool.
Chris Kinney
Reviewed in the United States on November 20, 2024
Last chance before breaking out the torch on a stripped exhaust Y pipe stud. Worked really well!
Shane
Reviewed in the United States on September 4, 2023
Awesome tool to have at home that was dual function. Worked very well for the job at hand
Keith W.
Reviewed in the United States on September 2, 2023
Better design and quality than the other I tried. I broke the other one with collet teeth.
Richard
Reviewed in the United States on August 9, 2022
Read the instruction provided! I was working on my 16 yr old 275k mile toyota sienna, i over tighten the thermostat housing bolt and it snapped... rather than get frustrated i searched to find solution... the broken bolt did not have enough thead on it.. i used a small vise grip.. turned it 1/8 at a time patiently. Now bought new bolts (decided to change all 3 and not just 1 broken one). Time to install and removed the 2 other bolts. This tool became handly on a very tight location. Patience is what you need to learn to use it and be careful. Quality for me is just fine, it did the work and it saved me money and time.
antonio aguilar
Reviewed in the United States on June 30, 2021
👍
jamie knowles
Reviewed in the United States on April 10, 2021
Have yet to try it but looks to be exactly what I needed
Recommended Products
$42.99
$ 22 .99 $22.99