Your cart is empty.
Your cart is empty.Product Description
Optimized Performance
Optimized weight and dyno-proven performance
Quality Construction
Stainless Steel construction for maximum durability and finish
Dependable Performance
Backed by MagnaFlow's dedication to manufacture products that are defect-free
Street Series
The Street Series Performance Exhaust system delivers dyno-proven power with a comfortable interior sound and performance exterior sound
Jdougheei🍩
Reviewed in the United States on February 23, 2021
Get what you pay for. Nice stainless setup, that goes up very easily in driveway on stands. As far as fitment issues others have, I don't see it. This was 1 of the easier catbacks I've installed. They take the guessing out of it with new hangers. It's not a coloring book tho, you have to put some effort into it. The🔑is to Follow The Directions...Do Not Tighten Everything..Until it is all in place where you want it...And THEN hold it and 🔩Snug it up and Tighten Again. May have to twist🔃the muffler to get the tailpipes in right spot. Squirting🔫the joints w a little💦lubricant will make things go smoother when adjusting.You'll have urself a nice ole rumblin Fbody. WOT is where it sounds the best, nice mellow rumble cruising, no drone. If your looking for obnoxious loud,this isn't the system for you tho🏎🏁.
Veronica
Reviewed in the United States on April 3, 2019
Installed on a 2000 Trans Am, just finished a forged LS1 build with a big ol Texas speed cam and CNC ported 243 heads. Long tubes and an off-road Y. Finished it off with a magnaflow catback. It’s very quiet and rumbly at low rpms and screams at high rpm. It did a very great job at turning my basically race car into a completely streetable ride. No drone whatsoever. All components are very high quality. I noticed a little while after that my tips were sitting uneven, they must’ve torqued when I tightened the clamps so I’ll have to mess with that a bit more.
Shaun Carver
Reviewed in the United States on July 18, 2017
Great product, but terrible fitment problems.
MrClean
Reviewed in the United States on June 12, 2016
I love this exhaust on my 02 Camaro ss. It has a nice mellow rumble when cruising and sounds great during "spirited" driving. Best of all very little drone inside the car. There is a small, but noticeable performance improvement. It is not very loud, so if you like loud exhaust look elsewhere. I was surprised at the high quality of the system and really liked the nifty hanger setup they included to make sure the tips don't move around (2 additional hangers besides the factory ones that hold the tailpipes/tips in place (my pic shows the passenger side tailpipe hanger)Update: After a couple days with this exhaust I noticed a few things. #1 The hanger on the driver side tailpipe is way too tall and cannot attach to the factory hanger properly (I even had to cut up the rubber hanger down to 1/3rd its original thickness for it to fit on there and even so it doesn't do anything it just floats between the two hangers instead of being supportive, see pic) I don't know how I didn't notice this during installation. #2 The passenger side tailpipe/tip is way closer to the center of the car then the driver side and looks pretty bad when you look at the car from behind. I have emailed magnaflow about these issues and am awaiting response. I will update this review accordingly.Update #2: I have modified a few things to get everything to fit decently. #1 The hanger that is too tall you have to cut it at the 90 degree bend at the top and then heat it up and bend it into a "new" hanger then it fits properly (see pic). #2 you have to cut about an inch off of the driver side outlet on the muffler and an inch off of the driver side tailpipe inlet and then cut new "slits" where the old ones were on the tail pipe inlet, This will allow you to move the driver side tailpipe more toward the center of the car. #3 Slide the passenger side tailpipe as far as you can off of the muffler without getting any leaks. By doing #2 and #3 this will greatly improve centering of the tips (originally the passenger side tip was way closer to the center then the driver side and looked terrible) its still not perfect, however.I don't understand how all these positive reviews don't have/mention any of these issues. How can magnaflow screw up the fitment this bad on such a common application? I'm still waiting on a response from them, maybe they will send me some proper fitting tailpipes but I doubt it.
hunterb
Reviewed in the United States on April 18, 2014
The exhaust arrived in two days and was very easy to install. All the brackets fit perfectly and the quality of the product is evident from the materials, finish and fit. I had a concern about the fit due to a factory installed fascia that lowers the back bumper on my 2002 Z-28 Camaro by 1 1/2". The system fit perfectly and looks and sounds awesome. I would recommend this product to any 2002 Z-28 Camaro owner if you want your car to sound like a true muscle car. Very Happy.
Armistice
Reviewed in the United States on February 23, 2013
Of all the performance upgrades I've made this is far and away the best (and easiest considering the work involved) one of the bunch. Like clearing a stuffy nose. Most of the actual work was removing the nasty old stock. (Had to cut the over-axle) All the parts fit perfectly every clamp every place.Best of all it gives voice to your V8, Deep, powerful, potentially aggressive but not so loud you become THAT neighbor everyone thinks is a right douche. Don't get me wrong, if you open her up she'll roar but its the perfect balance between growl and not being overbearing in the interior or to the outside world. Cannot praise this enough.
White Camaro
Reviewed in the United States on November 26, 2012
The components all look like good quality parts. Unfortunately, it did not come too close to fitting in my 1999 Z28. Besides not coming with the second page of instruction (just printed from the site), the kit did not exactly match the sketches either. The major problems were the following:1. They moved the intermediate pipe joint to the most space critical part of the design, exactly on top of the axle. You can just fit the clamp in there. It will most likely hit something all day long.2. The bracket attached to the muffler assembly can't properly attach to anything.3. The drivers side outlet bracket was miss placed as well.Definitely a return item.
Recommended Products
$1,089.23
$ 99 .00 $99.00
$564.99
$ 99 .00 $99.00