Your cart is empty.
Your cart is empty.
Warm Tips: It's a little tough to install because of the magnet. Take your time and be careful and you will be fine. Like any bolt, don’t get in a hurry and cross thread it. It should spin with little resistance once you get it in. Match the threads with the old bolt prior to installing just to check you have the correct one.
Package Includes:
1pc oil drain plug made of stainless steel 304 with neodymium magnet;
3pc aluminum crush washer;
Product Size:
M14*1.5P-H13, Hex size is 13mm, uses 13mm wrench.
Customer Service:
2 Years warranty, Worry-Free Return And Refund Policy.
Rob M
Reviewed in the United States on March 6, 2025
Just what I needed to replace the drain plug on 2017 Hyundai Sonata SE, fit fine, no leaks and gas magnet to catch any metal shavings.
GeoUser
Reviewed in the United States on January 30, 2025
More positive tightening than Audi's Torx Head. And you don't need to pack Torx as well, to get the job done.
WILLIAM MALDONADO
Reviewed in the United States on June 22, 2024
I installed this magnetic drain plug on my 2012 Hyundai Sonata Limited 2.4L and was pleasantly surprised by it's high quality and perfect fit.
K.Benge
Reviewed in the United States on December 25, 2024
Replaced a stripped oil drain plug in a 2010 Volkswagen Golf GTI. This fit great.
Mike parrott
Reviewed in the United States on November 29, 2024
Did not fit as described
Dee
Reviewed in the United States on October 28, 2024
Liked ver much
Joneph Singleton
Reviewed in the United States on April 7, 2024
Fits fine in my 2007 Honda Odyssey. Should also work fine in any other car with a J35 engine. It was cheaper to buy this plug with the included aluminum crush washer than it was to buy a crush washer by itself at a local auto parts store.It is stainless, and magnetic. I'll know in another 7,500 miles if the magnet stays magnetic, and stays attached.It is interesting to note that the head is very different from the original drain plug, and from most automotive fasters.The original drain plug has a formed head, and the replacement has a machined head.The original uses a 17mm wrench, while the replacement has a sloppy fit with a 15mm wrench and a reasonable fit with a 9/16" wrench -- which is weird.But it's installed and it is keeping the oil in the pan where it belongs.
Christian Mendez
Reviewed in the United States on April 27, 2024
Fit perfectly, I took off two stars bc it came with no washers
Recommended Products
