Your cart is empty.
Your cart is empty.Product Description
Solid and Durable Aluminum Motor Bracket
- Overall is made of Aluminum, Base is made of Plastic. Hp rating: 7-1/2 to 20, Broad Size: 8” × 10-1/5”, Mounting Size: 5-1/4” × 9”, maximum weight is 52kg (115lbs).
- Spring loaded (5 vertical position) adjustable bracket, Wide track body for added stability.
- Solid Polypropylene Mounting board. Easy to lift-heavy spring helps balance motor weight.
- Perfect for small to medium sized powerboats and yachts.
Kindle Customer
Reviewed in the United States on September 22, 2024
Solid, well made bracket for my kicker. Virtually identical to Panther for half the price.
Tone capone
Reviewed in the United States on July 15, 2024
Never got to use the bracket but, I installed it and did not work for my application. As the lever to acuate has zero clearance of boat/motor. However, it felt very sturdy.
Dennis
Reviewed in the United States on February 17, 2024
Great for my small kicker motor.
NC Basser
Reviewed in the United States on December 29, 2024
Very sturdy mount. Easy to install. Worked great for my 6.5HP kicker motor.
Daniel B.
Reviewed in the United States on December 28, 2024
Worked great for my kicker motor .
Greyeyes
Reviewed in the United States on October 17, 2024
Kicker motor died before I could install it, so it got returned. It looked like it would work just fine though.
J. Mark Malsom
Reviewed in the United States on October 1, 2024
This bracket is very sturdy. I have my 6 hp 57 lb. trolling motor hung on it. The bracket that attaches to the transom is 3/16" . The lifting/lowering mechanism is 3/8". I installed it by myself, but would have been nice to have a second set of hands when marking the position to drill on the transom. I measured the length of my motor shaft. I lowered the bracket to it's lowest position and attached a yardstick to the top of where the motor attaches to the bracket, marking the length of the shaft on the yardstick. I then lowered it to the position where the shaft length (at the cavitation plate) is even with the bottom of the hull. Marked the hole positions and drilled 5/16" holes to accommodate the carriage bolts, which were provided, but I had to get longer ones. When installing remember to use backing plates on the inside of the transom to distribute the load. No mounting instructions are included. If needed you can find instructions on the internet for other brands. They are all basically the same.
DOUGLAS P
Reviewed in the United States on August 7, 2023
The motor bracket has a long reach. It was used on a 24’ sailboat. A 2-1/2 hp Suzuki motor was mounted. One difficulty was rotating the motor up, the motor housing hit the handle and would not lock in place. I had to tie the motor up when rotated out of the water. This may be unique to the Suzuki motor. Another difficult was raising the motor from the fully down position. It was very difficult to disengage the locking lever. The motor needed to be pushed down a bit further to disengage the lever.
Recommended Products