Your cart is empty.
Your cart is empty.MEUS RACING 4WS Four-Wheel Steering Control Line with Control Board and Servo Control Lines, suitable for 4WS RC Crawler Car SCX10, TRX4, SCX24 TRX4M etc.
Bodie Clinkingbeard
Reviewed in the United States on March 7, 2025
Works great with stock SCX24 AX-4 Transmitter. I snipped off the Ch1-3 female connectors and the male Ch2 to slim it down and I’m running two completely different servos (Mofo BlackLabel DP-M up front w/ an emax in the rear), it has been functioning exactly as needed with no issues!
Roanna Burnell
Reviewed in the United States on February 3, 2025
After spending about 20 minutes to figure out on a 5 channel, got it working, also learned if you don’t have a fancy controller, but just a simple center steering adjuster, install the servos opposite, and they will center just fine.
Christopher J. Cole
Reviewed in the United States on July 14, 2024
Worked perfect.. setup was very easy...just got to make sure u plug the servoes in the right way...pay attention to the labels
devin lockwood
Reviewed in the United States on March 31, 2024
The media could not be loaded.
Caleb Harris
Reviewed in the United States on February 22, 2024
Easy to cycle through the different modes. I had to use the 2CH setting in order to work with the factory receiver
skwintyeyez
Reviewed in the United States on December 16, 2024
It's installation is a little tricky but not hard once u understand how it works the instructions are ok but not very clear so u have to try different lay outs and didn't need an xturnal battery. Works off 5.5v fine. Sorry no pics this time a u just burned up my pythonRXF an zilla motor! Sux.
L4J
Reviewed in the United States on October 9, 2024
I added a 4 wheel steering system to an SCX 24 and wanted more control over the rear steer than I could get with the stock setup and the limited control on channel 3. This unit works perfectly for the job. It's easy to select between Front, Rear, Both, and Crab modes and the controls match very closely front to rear.The only issue in this application is the size of the cables. The electronics are very compact, but the bundle of cables to connect to the RX is fairly bulky. It took some work to get it packaged cleanly (for some given value of cleanly) on my modified SCX24 chassis. The bulk of the wiring is tucked under the battery in the picture, but you can see how small the actual electronics are mounted below the RX.I may add 4 wheel steering to one or more of my 10th scale crawlers, where there's considerably more room to do a clean installation.
Donny Griffith
Reviewed in the United States on January 19, 2024
Once you figure out the module and installing it, it works awesome. I do highly recommend an aftermarket remote to trim channel 3 or 2.
Recommended Products
