Your cart is empty.
Your cart is empty.Product Description
Set Includes
- 7/8 Inch, SAE, CR-V, Deep, 1/2"Dr.
MIXPOWER 1/2-Inch Drive Deep Impact Socket - 7/8 Inch
Description
MIXPOWER 1/2-Inch Drive Deep Impact Socket is made from drop forged and heat treated chrome vanadium steel (50BV30). With corrosion-resistant black phosphate finish, providing the durability for a hard use. Radius corner, 6-point design turns the flat sides of the fastener and provides maximum torque, while preventing the corners from damaging.
Made from drop forged and heat treated chrome vanadium steel (50BV30).
Radius corner, 6-point design turns the flat sides of the fastener and provides maximum torque, while preventing the corners from damaging.
High-contrast size marking is permanently laser etched for easy identification even in low light.
Chris Alexander
Reviewed in the United States on March 8, 2025
It is a tough socket. 6 point. 22mm. Functions right. Sits quietly in.my tool bag until it needs to take a lug nut off. It does this without complaint and quietly awaits its next use.
David P. Woods
Reviewed in the United States on February 27, 2025
Fine
Richard
Reviewed in the United States on January 15, 2025
Works very well
Erik Nilsson
Reviewed in the United States on December 23, 2024
High quality
paul ellis
Reviewed in the United States on December 10, 2024
Well built, nice for the price.
Gail Pedrick
Reviewed in the United States on October 29, 2024
I bought this to keep in the truck for wheel lugs. I only use it with a breaker bar (no impact driver) and not very much. Does the job for my need.
Fuad
Reviewed in the United States on October 21, 2024
Good quality impact socket. Does what it should. Opens lug nuts with ease on my vehicle.
Christopher
Reviewed in the United States on April 19, 2024
This 19mm impact socket has been in use for 10 months in a professional automotive garage. It has performed perfectly as an impact socket without signs of wear. However, it did not survive being hammered onto a swollen lug nut. With one strike of a hammer, a 1.26 inch (roughly 32mm) crack formed from the 6-point business end, to right where the 19mm labeling begins.I do recommend this socket as it has handled everything my 1300 ft lb impact gun threw at it, but stress care when dealing with swollen lug nuts. Avoid pounding the socket onto a lug nut and instead, use an older, more worn out socket for any hammering purposes.End note: There is absolutely NO "wear and tear" with the 6-point opening nor with the 1/2 inch drive end. It was improper use which caused the fatal damage. In other words... it was my fault.
Tom Curran
Reviewed in Canada on September 25, 2023
Didn't have this size in my set. Good quality and will work for my application
Daniel
Reviewed in Canada on August 1, 2023
Outil de qualité
marilyn j
Reviewed in Canada on January 7, 2023
Pleased with product
Tchambe
Reviewed in Canada on May 25, 2022
Bought to undo wheel lugs and snapped on the fifth oneUpdate after my review company messaged me and sent a new socket at no charge very impressed will buy from them again
Sean
Reviewed in Canada on November 9, 2022
very happy with product!!
Recommended Products